Integra DPS-10.5 Connecting the Power Cord, Controlling Other Out-of-range Components

Connecting—Continued

Connect the IR receiver to the DPS-10.5 as shown below.

from connecting block

Miniplug cable

Signal flow

IR

IN

OUT

DPS-10.5

Controlling Other Out-of-range

Components

For another component that is out of range of its remote controller, you can use a commercially available IR emitter to retransmit the remote controller signals received at the DPS-10.5’s IR IN, as shown below.

picked up by the DPS-10.5’s remote control sensor are not.

Connecting the Power Cord

Notes:

• Before connecting the power cord, complete all of the
	necessary audio and video connections.
•	Do not use a power cord other than the one supplied
	with the DPS-10.5, which is designed exclusively for
	use with the DPS-10.5 and should not be used with
	any other component.
•	Never disconnect the power cord from the DPS-10.5
	while the other end is still plugged into a wall outlet.
	Doing so may cause an electric shock. Always discon-
	nect the power cord from the wall outlet first.
• The DPS-10.5 is shipped with the Standby/On button
	in the On position (	). When the power cord is con-
	nected for the very first time, the DPS-10.5 will go on

Connecting block

IR receiver

standby and the Standby indicator will light up.

• To completely shutdown the DPS-10.5, set the

IR IN
IR OUT	DPS-10.5

IR emitter

Remote controller

Other component

Signal flow

Connect the IR emitter to the DPS-10.5’s IR OUT, and place the IR emitter in front of the other AV component’s remote control sensor (usually located on its front panel), as shown below. See the instructions supplied with the IR emitter.

Other component

		Remote control
from connecting block		sensor
		IR emitter
	Miniplug cable
IR	Miniplug
IN
OUT
DPS-10.5	IR Emitter
		Signal flow

Only remote controller signals received by the DPS-10.5’s IR IN are fed through to the IR OUT. Signals

Standby/On button to the Off position ( ).

DVD CHANGER

MODEL NO. DPC-7.4

AC INLET

1	Plug the supplied power cord into the
	DPS-10.5’s AC INLET.
2	Plug the other end of the power cord into
	a suitable AC wall outlet.

The Standby indicator lights up.

37