Samsung SHR-7162, SHR-7082, SHR-7080 Changing the Remote Control ID, Press any button among 1 to

MONITOR

Available after switching to Monitor mode by pressing the [MONITOR] button on the remote control.

AUTO

Selects the screen status automatically．

P.MODE Selects the screen mode．

POWER

Turns the monitor power on/off．

NUMBER [0~9]

Changes the system ID.

+/-

Adjusts the audio volume．

MENU

Displays the Setup Menu．

ID RESET

Initializes the ID value to 01.

MONITOR

Activates the monitor function.

ID

Sets the ID.

Select 2 digits from 0 ~ 9 while pressing the ID Key.

MUTE

Mutes the audio out.

! overview

Up/Down/Left/Right($%_ +)/ENTER

Moves the cursor up/down/left/right, and runs the Select Menu.

FREEZE Screen Freeze．

UNDER SCAN

Displays the video screen within a screen．

SOURCE

Selects the input signal source.

PIP

Selects or deselects the PIP function.

Using the Numeric buttons

CHANNEL 1–9

Press any button among 1 to 9.

Changing the Remote Control ID

1.Press the ID button of the remote control and check the ID displayed on the DVR screen. The factory default ID of the remote control is 00.

2.Enter 2 digits of your selection in order, while pressing the system [ID] button.

3.When ID input is done, press the system [ID] button again to check the setting.

M	` If you want to change the remote control ID to 08: Press 0 and 8 in order while the system [ID] button is pressed.
	Remote control's ID and DVR’s ID should be matched for proper operation. Refer to “Remote Devices”. (Page 45)

English _13

00769B_SHR-8162_ENG-NEW.indb 13

2008-12-04 오전 10:13:40