Setting the event, Sensor detection, Event

~Disk End Mode : If selected <overwrite>, recording will continue despite the HDD full while overwriting the oldest.

If selected <stop>, the recording will stop when the HDD is full.

~Disk End Beep : If selected <stop>, the button is activated.

If you check it, the beep will sound on the disk full and the recording stops.

~Auto Delete : If you check it, Record Period setup is activated.

If you setup the auto delete, recorded data only in the confi gured period are searchable.

. When the recording option setup is done, press <oK>.

setting the event

You can set recording options for sensor, motion, and video loss event.

You can set the sensor’s operating condition and connected camera, as well as alarm output and its duration.

Using the mouse may help easy setup.

● using the dvr

1.Press the [menu] button on the remote control or front panel.

. Use the left/right button (_ +) to select <event>. Event setting menu is selected.

. Use the up/down buttons (▲▼) to move to <sensor detection>, and press [enter] button.

A window of sensor detection setup appears.

. Use direction buttons (▲▼_ +) to move to a desired item, and set the value.

~Sensor Operation : Sets the operation mode of sensors.

-<oFF> : Sensor does not operate.

-<n.o (normal open)> : Sensor is opened. If the sensor is closed, it generates alarm.

If the sensor is open by interruption, it generates alarm.

~Cam : Select a channel to be connected to the sensor.

If selected camera, “cam preset setup” window appears. Select a channel and setup the preset.

` Preset setup can be done in PTZ mode.

Sensor Detection

Motion Detection

Video Loss Detection

Alarm Schedule

Sensor Detection

English _1

00769B_SHR-8162_ENG-NEW.indb 51

2008-12-04 오전 10:15:39