Samsung SHR-8160, SHR-7082, SHR-7080 ~ Normal capacity 170mAh, ~ Continuous standard load 0.2mA

Page 4

overview

BEFORE START

This user’s manual provides Information for using DVR such as brief introduction, part names, functions, connection to other equipment, menu setup, and the like.

You have to keep in mind the following notices:

~SEC retains the copyright on this manual.

~This manual cannot be copied without SEC’s prior written approval.

~We are not liable for any or all losses to the product incurred by your use of non-standard product or violation of instructions mentioned in this manual.

~If you want to open the case of your system for checking problems, please consult the expert from the shop where you bought the product.

~You may download open source codes from the following website: www.samsungsecurity.com.

~Before installing an additional HDD or connecting an external storage device (USB memory or USB HDD) to this DVR, check the compatibility. Consult your provider for the compatibility list.

Warning

Battery

Exchanging a wrong battery in your product may cause an explosion. Therefore you must use the same type of battery as the one being used in the product.

The following are the specifications of the battery you are using now.

~ Normal voltage: 3V

 

CALIFORNIA USA ONLY

~ Normal capacity: 170mAh

This Perchlorate warning applies only to primary CR (Manganese Dioxide)

~ Continuous standard load: 0.2mA

Lithium coin cells in the product sold or distributed ONLY in California USA.

~ Operating temperature: -20°C ~ +85°C

“Perchlorate Material - special handling may apply,

See www.dtsc.ca.gov/hazardouswaste/perchlorate.”

(-4°F ~ +185°F)

 

 

 

The rechargeable battery incorporated in this product is not user replaceable.

For information on its replacement, please contact your service provider.

System Shutdown

Turning off the power while the product is in operation, or taking not permitted actions may cause damage to the hard drive or the product. Also it can cause a dysfunction to the hard disk while using the product. Please turn off the power using the Power button on the front of your DVR.

After selecting <OK> in the pop-up menu, you can pull off the power cord.

You may want to install a UPS system for safe operation in order to prevent damage caused by an unexpected power stoppage. (Any questions concerning UPS, consult your UPS retailer.)

Operating Temperature

The guaranteed operating temperature range of this product is 0°C ~ 40°C (32°F ~ 104°F).

This product may not work properly if you run right after a long period of storage at a temperature below the guaranteed one.

When using the device after a long period of storage at low temperature, place the product at room temperature for a while and run it.

Especially for the built-in HDD in the product, its guaranteed temperature range is 5°C ~ 55°C (41°F ~ 131°F). Likewise, the hard drive may not work at a temperature below the guaranteed one.

_ overview

00769B_SHR-8162_ENG-NEW.indb 4

2008-12-04 오전 10:13:18

Image 4
Contents Channel/16 Channel DVR Features OverviewImportant Safety Instructions Overview~ Normal capacity 170mAh ~ Operating temperature -20C ~ +85C~ Continuous standard load 0.2mA Package Contents Standards ApprovalsContents Web viewer Backup viewerAppendix Part Names and Functions Front Alarm RECMode AudioPart Names and Functions Rear 7080/7082 RearVideo OUT Audio OUTVGA HdmiRemote Control Using the numeric buttonsChannel Press each button between 1 toChanging the Remote Control ID Press any button among 1 toInstallation ChecKing the instaLLation environmentRacK instaLLation InstaLLationHdd addition ` Fix the screws not to be loosened by vibrationsIf adding hdds to shr-7080, 7160, 8080 Adding a hdd` For SHR-7082/7162/8082/8162 models, see the following If adding hdds to shr-7082, 7162, 8082 Installed by default Connecting the Video, Audio, and Monitor Connecting the NetworkConnecting to Internet through Ethernet 10/100/1000BaseT ` The following figures are based on Model SHR-8162Connecting External Sata HDD Connecting the USBConnecting to Internet through Adsl Connecting POS Device Connecting the Alarm Input/OutputConnecting the RS-485 Device Starting the system Getting startedShutting down the system Login Fi gureLive Screen Configuration Icons on the Live ScreenError information Split mode menuSplit Mode Menu Single Mode MenuSingle mode menu ZoomView the Launcher menu PTZLive Mode Switching the screen modeSwitching the split mode Auto SequenceChannel Setting Manual SwitchingSwitching to single mode Selecting a spot out modeSpot out Audio on/oFF in single mode ZoomAudio on/oFF FreeZeEvent Monitoring Setting the date/time/Language System setupDate/time/Language Setting holiday Using the calendarSetting the administrator You can set and change Administrator’s ID and password. When the administrator setup is done, press oK Permission managementSetting the group Setting the userSetting permissions System managementChecking the system information System ManagementUsing the dvr System Upgrade BroadcastS/W Upgrade ~ Updating the SoftwareLog information SettingsSystem Log Setting the device Setting the cameraCamera Event LogSetting the ptZ . When the PTZ setup is done, press oKConfi rming devices Storage deviceFormatting Hdd alarm HDD AlarmAppears on the Live screen ManageRemote devices Pos devicesWill not be saved Remote DeviceSetting the monitor MonitorSetting the spot out Setting the screen modeSetting the recording Recording scheduleRecord Recording ScheduleQuality / resolution Setting standard recording propertiesEvent record duration Recording color tagsResolution Setting event recording propertiesRecord option Setting the event Sensor detectionNormal close Sensor is closed EventSetting the motion detection area Motion detectionMotion Detection Sensor DetectionAlarm schedule Stop the alarm by canceling the schedule. When the Alarm Schedule setup is done, press oK Alarm ScheduleBacKup Setting the BackupYou can backup the desired data to a connected device BackupNetworK conFiguration Connection modeSetting the connection You can set the network connection route and protocolSetting the protocol ProtocolConnecting and setting the network When no router is used~ dynamic ip dhcp mode Ddns192.168.0.254 When a router is usedNetwork Live transfer Ddns settingLive Transfer Mailing service Smtp settingEvent setting Mailing ServiceGroup setting Recipient settingUsingthe GroupAdd UserUsing the ptZ camera ControLLing a ptZ devicePtZ device Getting started with ptZPreset setting Camera setting. Press oK Preset will be saved as a name that you entered AccordinglyIt does not appear in Backup Search SearchTime search You can search for recorded data of a desired timeBackup search Event searchPos search Motion searchPOS Search Motion SearchPLayBacK Backup RangePlay What is Web Viewer? Introducing Web Viewer` All settings are applied by the DVR’s settings Connecting weB viewer. Click install activex control… WeB viewer 0 web viewer Using Live viewer You can change the split mode by clicking each number icon Single Mode Quad Mode Nine ModeOsd inFormation dispLay SpLit-screenConnected dvr Changing the Live screen mode` The number of simultaneous connections are limited to ~ capture Saves the current screen into a BMP or Jpeg fi le Saving the Live screen on the pcIt cannot be modified Using ptZ camera Changing the Live screen channeLPan/Tilt of the Smart dome camera is manipulated ` Tilt of Power PTZ operates properly withinEx Samsung SCC-C6475 Using search viewer Single Mode Sixteen ModeWeb Viewer\VideoClip\Search. To change the saving path Searching the recorded video in the caLendar Searching the recorded video in the timeLineViewer setup You can confi gure the various settings of the DVR systemSystem ControLLing pLayBacKHoliday Permission managementSystem management Camera DeviceStorage device Pos device Remote deviceMonitor For more information, refer to setting the recording. RecordRecording schedule ~ Spot OUTRec Quality & resolution EventEvent record duration Record optionAlarm schedule You can set the alarm output time if a video loss occursMotion detection Video Loss detectionNetwork ConnectionDdns Live transferMailing service ABout Sec BacKup viewer Recommended system requirementsYou can adjust the volume level from 0 to Speed will restore toBetween activated and deactivated BMP and JpegProduct Specification PALCifs USB HDDSata HDD AppendixSata HDD-MAX Product OVERView ~ SHR-8162Default Setting ManagementDuration Smtp Troubleshooting DVR Preamble We protect your rights with two stepsOn the Program is not required to print an announcement No Warranty How to Apply These Terms to Your New Programs END of Terms and ConditionsTerms and Conditions Appendix English Additional Terms Patents No Surrender of Others FreedomLimitation of Liability Revised Versions of this LicenseEND of Terms and Conditions Do these things Is included without limitation in the term modification English Promoting the sharing and reuse of software generally How to Apply These Terms to Your New Libraries Copyright C year name of authorOpenSSL License Loss of USE, DATA, or Profits or Business InterruptionThis Software is Provided by Eric Young ‘‘AS IS’’ Correct disposal of batteries in this product