Philips SBC RU 520/87U manual Automatically setting the remote control

XP SBC RU 520/87.3 06-02-2004 16:25 Pagina 7

Instructions for use

Automatically setting the remote control

If you cannot find the right code for your brand device,

the remote control can automatically search for the right code.

Example of TV:

1Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1).

The RU520 emits the ‘switch off TV’ signal for all models of TV that are stored in the memory.

•If the device is a DVD-player or video recorder, insert a disk or tape and start playback.

2	Then keep keys 1 and 3 on the RU520	M	E	N	U	K
						O
	pressed simultaneously for three seconds,	1			2	3
	until the green light under TV in the selector
		4			5	6
	window flashes twice and then remains lit.
		7			8	9
		SHIFT			0

3Press the Standby key of the RU520 briefly.

TV VCR/DVD

English

–The RU520 now starts emitting all known ‘TV off ’ signals, one by one.

Each time a code is sent, the green light under TV in the selector window lights up.

4When your TV switches off (stand-by), you press the Standby key of the RU520 twice within 1 second, to confirm.

–The RU520 has now found a code that works on your TV.

TV VCR SAT DVD

2x

TV VCR/DVD

5 Check if you can operate all functions on your TV with the RU520.

•If this is not the case, you can redo the automatic setting. The RU520 will then search for a code that perhaps works better.

–After the RU520 has run through all the known codes,

the search will stop automatically and the green light will stop flashing.

–Automatic programming of a TV takes a maximum of 5 minutes. For VCR/DVD this time is 2 minutes.

7