Zebra Technologies P1071336-002 manual Installing in a Windows Operating System

Page 14

14

Installation

Installing in a Windows Operating System

Installing in a Windows Operating System

Minimum System Requirements

The SOTI MobiControl Connector supports the 64-bit version of the following:

Windows Server 2008

Windows Server 2008 R2 (also known as Windows 7 Server)

Note • This system should be installed on a “clean” Windows Server. A clean system is one that does not already include Apache Tomcator any other server software installation.

Tomcat will be installed as part of this installation procedure and must be the only Tomcat version resident on this system. Multiple versions of Tomcat will encounter conflicts.

The PC must have direct access (not through a proxy) to the Internet to complete the Connector installation. Once the installation is complete, the PC and the SOTI MobiControl Connector may be configured for internal access only, if needed.

P1071336-002

1/20/15

Image 14
Contents Soti Page 20/15 P1071336-002 P1071336-002 20/15 Contents WebLink Set/Get/Do Commands About This Document Who Should Use This Document How This Document Is OrganizedDocument Conventions Icons UsedAbout This Document Introduction Supported Printers What Soti MobiControl Connector DoesOverview Supported Operating SystemsInstallation Installing in a Windows Operating System Minimum System RequirementsInstallation Steps Install a MobiControl ServerInstallation My Documents\zebracerts\ Click Finish Install Software Installation Mypasserver.com Mypc.company.lan Enter the password selected in on Installation Enable Printer Discovery Test a PrinterInstallation Installation Installation Installation Set Up Printers Discover Your Printers Configuring Printers with WebLink When a Proxy Server is Part of the Network Configuration Configuring WeblinkBasic Configuration When Http Authentication is Necessary To remove authentication credentials issue the followingDifference Between Conn1 and Conn2 Additional Firewall ConfigurationEnable Logging Navigating the Log Output Configuring Printers with WebLink Troubleshooting Locating the Soti MobiControl Connector Log File Installation ErrorsRestarting the Soti MobiControl Connector SSL/TLS Certificate Errors Value that it was last set to. This does not mean the valueIncorrect. Check that the printer’s date and time rtc.date Other Typical Errors CommunicationTroubleshooting Http Messages Troubleshooting WebLink Set/Get/Do Commands Introduction to SGD Commands Weblink.enable Weblink.ip.conn12.authentication.add Entries Weblink.ip.conn12.authentication.entries Weblink.ip.conn12.authentication.remove Weblink.ip.conn12.enable Weblink.ip.conn12.location Weblink.ip.conn12.maximumsimultaneous connections This command assigns the URL of the connection proxy Weblink.ip.conn12.proxyHttp//usernamepassword@mydomain.com3128 Http//mydomain.com Default Weblink.ip.conn12.retryintervalWeblink.ip.conn12.test.location WebLink Set/Get/Do Commands Weblink.ip.conn12.test.retryinterval Default failure Weblink.ip.conn12.test.testonWebLink Set/Get/Do Commands This command clears the weblink log entires Weblink.logging.clearWeblink.logging.entries Supported DevicesWeblink.logging.maxentries WebLink Set/Get/Do Commands Weblink.printerresetrequired Weblink.restoredefaults This command defaults the weblink branch settings20/15 P1071336-002 Zebra Technologies Europe Limited