Zebra Technologies P1071336-002 manual Discover Your Printers

Page 30

30

Installation

Installation Steps

Discover Your Printers

1.Click the Printer tab and Devices in the taskbar (at the bottom of the screen).

2.Select the top level Device Group in the left pane.

Note • If you don’t see your printer listed after several minutes, reset the printer.

3.Select one of the printers in the center pane.

4.Click Information in the right pane to see more detailed information about the selected printer.

P1071336-002

1/20/15

Image 30

Contents Soti Page 20/15 P1071336-002 P1071336-002 20/15 Contents WebLink Set/Get/Do Commands About This Document Who Should Use This Document How This Document Is OrganizedDocument Conventions Icons UsedAbout This Document Introduction Supported Printers What Soti MobiControl Connector DoesOverview Supported Operating SystemsInstallation Installing in a Windows Operating System Minimum System RequirementsInstallation Steps Install a MobiControl ServerInstallation My Documents\zebracerts\ Click Finish Install Software Installation Mypasserver.com Mypc.company.lan Enter the password selected in on Installation Enable Printer Discovery Test a PrinterInstallation Installation Installation Installation Set Up Printers Discover Your Printers Configuring Printers with WebLink Configuring Weblink Basic ConfigurationWhen a Proxy Server is Part of the Network Configuration When Http Authentication is Necessary To remove authentication credentials issue the followingAdditional Firewall Configuration Enable LoggingDifference Between Conn1 and Conn2 Navigating the Log Output Configuring Printers with WebLink Troubleshooting Installation Errors Restarting the Soti MobiControl ConnectorLocating the Soti MobiControl Connector Log File SSL/TLS Certificate Errors Value that it was last set to. This does not mean the valueIncorrect. Check that the printer’s date and time rtc.date Other Typical Errors CommunicationTroubleshooting Http Messages Troubleshooting WebLink Set/Get/Do Commands Introduction to SGD Commands Weblink.enable Weblink.ip.conn12.authentication.add Entries Weblink.ip.conn12.authentication.entries Weblink.ip.conn12.authentication.remove Weblink.ip.conn12.enable Weblink.ip.conn12.location Weblink.ip.conn12.maximumsimultaneous connections This command assigns the URL of the connection proxy Weblink.ip.conn12.proxyHttp//usernamepassword@mydomain.com3128 Http//mydomain.com Default Weblink.ip.conn12.retryintervalWeblink.ip.conn12.test.location WebLink Set/Get/Do Commands Weblink.ip.conn12.test.retryinterval Default failure Weblink.ip.conn12.test.testonWebLink Set/Get/Do Commands This command clears the weblink log entires Weblink.logging.clearWeblink.logging.entries Supported DevicesWeblink.logging.maxentries WebLink Set/Get/Do Commands Weblink.printerresetrequired Weblink.restoredefaults This command defaults the weblink branch settings20/15 P1071336-002 Zebra Technologies Europe Limited