Zebra Technologies P1071336-002 manual Enter the password selected in on

Page 22

22

Installation

Installation Steps

6.Fill in all of the open fields in this form.

The MobiControl Server Location is the Deployment Server End Point to which SOTI MobiControl Connector is connected.

a.The MobiControl Server location is usually going to have the format of your MobiControl Server DNS name followed by mc/pas (see the example below). For example: https://mobicontrol.com/mc/pas/

b.Enter the name of the PAS Server from step 6 on page 16.

c.The certificate (downloaded in step 12 on page 18) will be located in the following directory:

My Documents\zebra_certs\

d.Enter the password selected in step 10 on page 18.

P1071336-002

1/20/15

Image 22
Contents Soti Page 20/15 P1071336-002 P1071336-002 20/15 Contents WebLink Set/Get/Do Commands About This Document Who Should Use This Document How This Document Is OrganizedDocument Conventions Icons UsedAbout This Document Introduction Supported Printers What Soti MobiControl Connector DoesOverview Supported Operating SystemsInstallation Installing in a Windows Operating System Minimum System RequirementsInstallation Steps Install a MobiControl ServerInstallation My Documents\zebracerts\ Click Finish Install Software Installation Mypasserver.com Mypc.company.lan Enter the password selected in on Installation Enable Printer Discovery Test a PrinterInstallation Installation Installation Installation Set Up Printers Discover Your Printers Configuring Printers with WebLink Basic Configuration Configuring WeblinkWhen a Proxy Server is Part of the Network Configuration When Http Authentication is Necessary To remove authentication credentials issue the followingEnable Logging Additional Firewall ConfigurationDifference Between Conn1 and Conn2 Navigating the Log Output Configuring Printers with WebLink Troubleshooting Restarting the Soti MobiControl Connector Installation ErrorsLocating the Soti MobiControl Connector Log File SSL/TLS Certificate Errors Value that it was last set to. This does not mean the valueIncorrect. Check that the printer’s date and time rtc.date Other Typical Errors CommunicationTroubleshooting Http Messages Troubleshooting WebLink Set/Get/Do Commands Introduction to SGD Commands Weblink.enable Weblink.ip.conn12.authentication.add Entries Weblink.ip.conn12.authentication.entries Weblink.ip.conn12.authentication.remove Weblink.ip.conn12.enable Weblink.ip.conn12.location Weblink.ip.conn12.maximumsimultaneous connections This command assigns the URL of the connection proxy Weblink.ip.conn12.proxyHttp//usernamepassword@mydomain.com3128 Http//mydomain.com Default Weblink.ip.conn12.retryintervalWeblink.ip.conn12.test.location WebLink Set/Get/Do Commands Weblink.ip.conn12.test.retryinterval Default failure Weblink.ip.conn12.test.testonWebLink Set/Get/Do Commands This command clears the weblink log entires Weblink.logging.clearWeblink.logging.entries Supported DevicesWeblink.logging.maxentries WebLink Set/Get/Do Commands Weblink.printerresetrequired Weblink.restoredefaults This command defaults the weblink branch settings20/15 P1071336-002 Zebra Technologies Europe Limited