Zebra Technologies P1071336-002 manual Installation Steps, Install a MobiControl Server

Page 15

Installation

Installation Steps

Installation Steps

Step 1: Install a MobiControl Server

1.Contact SOTI.

a.Contact SOTI Customer Support to obtain an MobiControl version 12.0 or later installation.

b.Visit https://www.soti.net/services/support/mobicontrol/.

2.Log in to the SOTI MobiControl Console using the username and password provided by the SOTI Customer Support.

3.Click on the All Platforms tab.

4.At the bottom of the screen, click on Servers.

5.Right-click on Printer Administration Servers, and then click Create PAS Interface.

15

1/20/15

P1071336-002

Image 15

Contents Soti Page 20/15 P1071336-002 P1071336-002 20/15 Contents WebLink Set/Get/Do Commands About This Document How This Document Is Organized Who Should Use This DocumentIcons Used Document ConventionsAbout This Document Introduction Supported Operating Systems What Soti MobiControl Connector DoesOverview Supported PrintersInstallation Minimum System Requirements Installing in a Windows Operating SystemInstall a MobiControl Server Installation StepsInstallation My Documents\zebracerts\ Click Finish Install Software Installation Mypasserver.com Mypc.company.lan Enter the password selected in on Installation Test a Printer Enable Printer DiscoveryInstallation Installation Installation Installation Set Up Printers Discover Your Printers Configuring Printers with WebLink Configuring Weblink Basic ConfigurationWhen a Proxy Server is Part of the Network Configuration To remove authentication credentials issue the following When Http Authentication is NecessaryAdditional Firewall Configuration Enable LoggingDifference Between Conn1 and Conn2 Navigating the Log Output Configuring Printers with WebLink Troubleshooting Installation Errors Restarting the Soti MobiControl ConnectorLocating the Soti MobiControl Connector Log File Value that it was last set to. This does not mean the value SSL/TLS Certificate ErrorsIncorrect. Check that the printer’s date and time rtc.date Communication Other Typical ErrorsTroubleshooting Http Messages Troubleshooting WebLink Set/Get/Do Commands Introduction to SGD Commands Weblink.enable Weblink.ip.conn12.authentication.add Entries Weblink.ip.conn12.authentication.entries Weblink.ip.conn12.authentication.remove Weblink.ip.conn12.enable Weblink.ip.conn12.location Weblink.ip.conn12.maximumsimultaneous connections Weblink.ip.conn12.proxy This command assigns the URL of the connection proxyHttp//usernamepassword@mydomain.com3128 Http//mydomain.com Weblink.ip.conn12.retryinterval DefaultWeblink.ip.conn12.test.location WebLink Set/Get/Do Commands Weblink.ip.conn12.test.retryinterval Weblink.ip.conn12.test.teston Default failureWebLink Set/Get/Do Commands Weblink.logging.clear This command clears the weblink log entiresSupported Devices Weblink.logging.entriesWeblink.logging.maxentries WebLink Set/Get/Do Commands Weblink.printerresetrequired This command defaults the weblink branch settings Weblink.restoredefaults20/15 P1071336-002 Zebra Technologies Europe Limited