Zebra Technologies P1071336-002 Who Should Use This Document, How This Document Is Organized

Page 8

8

About This Document

Who Should Use This Document

Who Should Use This Document

This User Guide is intended for use by any person who needs to install, perform routine maintenance, upgrade, or troubleshoot problems with the SOTI MobiControl Connector software.

How This Document Is Organized

The User Guide is set up as follows:

Section	Description

Introduction	This section provides general information about
	the SOTI MobiControl Connector.

Installation	This section outlines the system requirements for
	installation and provides specific details for the
	installation of SOTI MobiControl Connector.

Configuring Printers with WebLink	This section describes basic, network, and firewall
	configurations for printers connected to SOTI
	MobiControl Connector.

Troubleshooting	This section provides troubleshooting information
	about the SOTI MobiControl Connector.

WebLink Set/Get/Do Commands	This section describes the Set/Get/Do commands,
	parameters, and values that are available with
	SOTI MobiControl Connector.

P1071336-002

1/20/15

Image 8

Contents Soti Page 20/15 P1071336-002 P1071336-002 20/15 Contents WebLink Set/Get/Do Commands About This Document Who Should Use This Document How This Document Is OrganizedDocument Conventions Icons UsedAbout This Document Introduction What Soti MobiControl Connector Does OverviewSupported Printers Supported Operating SystemsInstallation Installing in a Windows Operating System Minimum System RequirementsInstallation Steps Install a MobiControl ServerInstallation My Documents\zebracerts\ Click Finish Install Software Installation Mypasserver.com Mypc.company.lan Enter the password selected in on Installation Enable Printer Discovery Test a PrinterInstallation Installation Installation Installation Set Up Printers Discover Your Printers Configuring Printers with WebLink When a Proxy Server is Part of the Network Configuration Configuring WeblinkBasic Configuration When Http Authentication is Necessary To remove authentication credentials issue the followingDifference Between Conn1 and Conn2 Additional Firewall ConfigurationEnable Logging Navigating the Log Output Configuring Printers with WebLink Troubleshooting Locating the Soti MobiControl Connector Log File Installation ErrorsRestarting the Soti MobiControl Connector SSL/TLS Certificate Errors Value that it was last set to. This does not mean the valueIncorrect. Check that the printer’s date and time rtc.date Other Typical Errors CommunicationTroubleshooting Http Messages Troubleshooting WebLink Set/Get/Do Commands Introduction to SGD Commands Weblink.enable Weblink.ip.conn12.authentication.add Entries Weblink.ip.conn12.authentication.entries Weblink.ip.conn12.authentication.remove Weblink.ip.conn12.enable Weblink.ip.conn12.location Weblink.ip.conn12.maximumsimultaneous connections This command assigns the URL of the connection proxy Weblink.ip.conn12.proxyHttp//usernamepassword@mydomain.com3128 Http//mydomain.com Default Weblink.ip.conn12.retryintervalWeblink.ip.conn12.test.location WebLink Set/Get/Do Commands Weblink.ip.conn12.test.retryinterval Default failure Weblink.ip.conn12.test.testonWebLink Set/Get/Do Commands This command clears the weblink log entires Weblink.logging.clearWeblink.logging.entries Supported DevicesWeblink.logging.maxentries WebLink Set/Get/Do Commands Weblink.printerresetrequired Weblink.restoredefaults This command defaults the weblink branch settings20/15 P1071336-002 Zebra Technologies Europe Limited