Operating Your SDI Video Matrix Switcher
out # x
from in # y
Where x is the output number and y is the input number
Pressing an
To switch one input to one output (CONFIRM mode):
1.Repeat step 1 above.
2.Press the appropriate IN button.
The MATRIX Display shows the 2 blinking digits, representing the input number and the TAKE LED blinks.
The STATUS Display shows1 the message:
out # x
from in # y
Where x is the output number and y is the input number
3.Press the TAKE button to confirm the action.
The output switches to the input and the TAKE LED lights.
7.2.2.2Switching Several Inputs to Several Outputs
In the AT ONCE mode, you need to execute each
In the CONFIRM mode you can
To switch several inputs to several outputs in the CONFIRM mode (the TAKE LED is lit), do the following:
1.Press the appropriate OUT button.
The MATRIX Display shows the 2 blinking digits, representing the previous input number for that specific output2. If the previous input is clear, the 2 blinking digits 00 appear in the MATRIX Display.
The STATUS Display shows the message:
out # x
Where x is the output number
1 Continuously, within the limit of the timeout (approximately 30 seconds)
2 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9
21