Kramer Electronics VS-1616SDI Identify Machine Yes TAKE, next Menu, Choosing the Initial Reset

Using the MENU Command Sequence

1.Press the MENU button until you reach the Identifying the MACHINE command.

The MATRIX Display shows the message:

identify MACHINE

yes -> TAKE, next -> MENU

2.Press the TAKE button.

The MATRIX Display (as Figure 16 illustrates) shows the message:

Figure 16: Machine Identification

8.11Choosing the Initial RESET

Choose to reset the machine1 to the:

￿Current status2 (reloads the current setup)

￿Factory default (resets to the pre-installed factory default state3)

To reset the machine, do the following:

1.Press the MENU button until you reach the initial RESET command. The MATRIX Display shows the message:

initial RESET

yes -> TAKE, next -> MENU

2.Press the TAKE button.

The MATRIX Display shows the message:

Outkey 1: Current status

2:Factory default

3.Press the OUT button 2, for example, to reset to the factory default. The TAKE LED blinks and the Displays show the messages:

Reset to factory default	WARNING
Press TAKE to execute	!!!!!

1 Without having to switch the power off and on 2 Sometimes called a “soft reset”

3 Each VS-1616SDI unit ships in its factory default state that is a 16x16 SDI video matrix, with all setups empty and each input connected to its corresponding output (for example, 1-to-1)

39