Operating Your SDI Video Matrix Switcher
7.2.1.1 Toggling Between the AT ONCE and CONFIRM Modes
To toggle between the AT ONCE (default) mode and the CONFIRM mode, press the TAKE button.
In CONFIRM mode: Actions require user confirmation and the TAKE LED lights.
In AT ONCE mode: Actions do not require user confirmation and the TAKE LED does not light.
When the TAKE LED blinks:
You cannot toggle between the AT ONCE and CONFIRM modes
You can execute the previous action, by pressing the TAKE button
You can cancel the previous action, by pressing a
7.2.2Switching Outputs
You can switch:
One input to one output (see section 7 .2.2.1)
Several inputs to several outputs (see section 7 .2.2.2)
One input to all outputs (see section 7 .2.2.3)
7.2.2.1 Switching One Input to One Output
Pressing an
To switch one input to one output (AT ONCE mode):
1.Press the appropriate OUT button.
The MATRIX Display shows the 2 blinking digits, representing the present input number connected to that specific output1. If the present output is clear, the 2 blinking digits 00 appear in the MATRIX Display.
The STATUS Display shows the message:
out # x
Where x is the output number
2.Press the appropriate IN button.
The output switches to the input and the MATRIX Display shows the Input
# instead of the blinking digits.
The STATUS Display momentarily shows the message:
1 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9
20 | KRAMER: SIMPLE CREATIVE TECHNOLOGY |
|