Kramer Electronics VS-1616SDI user manual Feature Function

Your SDI Video Matrix Switcher

Table 2: Front Panel VS-1616SDI 16x16 SDI Video Matrix Switcher Features

#	Feature	Function
1	IR Receiver	The red LED is illuminated when receiving signals from the
		Kramer Infra-red remote control transmitter
2	Power Switch	Illuminated switch supplying power to the unit
3	ALL Button	Pressing ALL followed by an INPUT button, connects that input to
		all outputs
4	OFF Button	An OFF-OUTcombination disconnects that output from the inputs;
		an OFF-ALLcombination disconnects all the outputs
5	IN Buttons	Select the input to switch to the output
6	OUT Buttons	Select the output to which the input is switched
7	STO Button	Stores the current setting in the non-volatile memory
8	RCL Button	Recalls a setup from the non-volatile memory
9	LCD MATRIX Display1	Displays the selected input(s) switched to the output(s) (above or
		below the corresponding OUTPUT label) and user interface
		messages
10	LCD STATUS Display1	Displays the matrix status (input to output connections)
11	MENU Button	Selects the programming commands to setup the switcher
12	TAKE LED	Shows the current TAKE button mode
13	TAKE Button	Used to confirm and complete setup and switching
	Table 3: Rear Panel VS-1616SDI 16x16 SDI Video Matrix Switcher Features
#	Feature	Function
14	DIGITAL	Space for optional digital Genlock input board with BNC
		Connector
15	EXT. SYNC BNC Connector	Connects to the external sync source
16	ANALOG BNC Connector	Connects to the analog Genlock source
17	75 ￿ Analog Genlock Button	Press to terminate at 75 ￿ or release for looping2
18	EXT. (extension) KEYS	Connects to an external keyboard (remote unit)
	Terminal Block Connectors
19	RS-485Detachable Terminal	Pins # 1 and # 2 are for vertical sync and Ground connection, and
	Block Port	Pins # 3 and # 4 are for RS 485
20	RS-232 IN DB 9F Port	Connects to the PC or the Remote Controller3
21	RS-232 OUT DB 9M Port	Connects to the RS-232 IN DB 9F port of the next unit in the
		daisy-chain connection
22	SETUP Dipswitches	Dipswitches for setup of the unit
23	Power Connector with Fuse	AC connector enabling power supply to the unit
24	INPUTS BNC Connectors	Connect to the digital video sources
25	OUTPUTS BNC Connectors	Connect to the digital video acceptors

1 In sections 7￿ .2.4 and 8,￿ the word “Displays” refers to the LCD MATRIX and STATUS Displays 2 Push in to terminate the sync line. Push out when the sync line extends to another unit

3 If the unit is not the first unit in the line, connects to the RS-232 OUT DB 9F port of the previous unit in the line

5