Enterasys Networks X009-U manual Installing IOMs

									Installing and Removing Modules
Figure 3-18 Installing IOMs
							GROUND	Matrix
						S/N: MAC ADD.	STRAP
								X4
							4
							3
								FAN
								TRAY
		FM2					CM2
		FM1					CM1
							2
	1						1	FAN		4
								TRAY
	4									3
		3		X-M2-0010G ENET STATUS	TX RX		TX	RX	S/N:	MAC ADD.
					TX RX		TX	RX
						2
					5			5
1 IOM slot 1	2	IOM	3	Captive screws (2)		4	IOM guide rails			5	Ejector handles

Figure 3-19 Engaging Ejector Handles
2	3	2	3
	4		5
1		1

1	Module	3	Chassis rail	5 Ejector handle (closed)
2	Slot	4	Ejector handle (open)

7.To install additional modules, remove the coverplates from the slots, as shown in Figure 3‐20, and repeat earlier steps. Save coverplates for optional future use.

8.After completing all module installation, be sure that you leave no slots uncovered. Failure to seal any empty slots with the provided coverplates, may hamper power cooling of the chassis and its components.

9.To remove an installed IOM, first disconnect any cabling and perform installation steps in reverse.

Matrix X4-C Chassis Installation Guide 3-19