Enterasys Networks X009-U manual CM1

Features

5.Insert the standby CM into the system and wait until it is fully synchronized with the active CM before removing the active CM. Do not physically remove the active CM during the synchronization process. The following message will appear on your console screen:

MXS Standby: Synchronization monitoring system

MXS CM Standby: SYNCING DATA. Do not remove the Active CM

configuration data 124 MB Copying 10.4%(2006 KBPS)00m56s remain high-availability data256 MB Copy-Pending

6.To manually check the state of the synchronization process, enter the show system high‐ availability command which will display the following output:

matrix-x(switch-su)-> show system high-availability

SYSTEM HIGH-AVAILABILITY INFORMATION

------------------------------------

System Coldstart:				Wed Mar	9 12:28:24 2005
Current Time:				Wed Mar	9 18:36:06 2005
Total System Uptime:				0d06h07m42s
HA-Channel:				Primary - Online
Configuration:				Non-Redundant (Coldstart after Reboot)
Total Failovers Since Coldstart:				0
Early Repetitive Failure Protection: 10m00s, 00n45s remain
Active Module:				CM1
Standby Module:				Synchronizing
CONTROL MODULE INFORMATION
--------------------------------				Uptime:0d00h54m08s 1.3.2.N
CM1	In-Service	Active
CM2	In-Service	Standby
Replication Status:
--------------------------------
configuration data		124 MB	Copying 10.4%(2006 KBPS)00m56s remain
high-availability data 256 MB			Copy-Pending

The following conditions are preventing a Hot-Redundant configuration:

--------------------------------

*Hot-Failover is disabled

*Early repetitive failure protection timer has not expired

*Synchronizing configuration data

*Synchronizing high-availability data

After a few minutes this message will appear on the Standby Control Module indicating synchronization is complete:

MXS Standby: Availability monitor Wed Jan 10 10:26:00 2007

MXS CM Hot In-Service Standby: Waiting for failover

Total System Uptime: 23d14h08m12s

Matrix X4-C Chassis Installation Guide 1-5