TRENDnet TV-IP302PI manual Factory Default, ∙ Time Switch mode

Page 34

TRENDnet User’s Guide

∙Time Switch mode:

Click "Pulse", the camera will trigger the external output devise for several seconds. The duration length is according to the "interval" setting in Output Setting.

Event Configuration >> Logs

Click "Logs" to see System Logs, Motion Detection Logs, GPIO Logs and All Logs. If you remove the power from IP camera, Motion Detection Logs will be cleared away.

TV-IP302PI

Factory Default

If you forget your password, please follow the steps to revert back to default value.

1.Remove the power and network cable.

2.Take the included Reset Wire Cable, plug one side of the wire into "Default" and the other side into "GND" on the terminal block as the picture below.

3.Connect power to the camera again. It takes around 30 seconds to boot the camera.

4.Remove the wire and plug in the network cable after the camera finishes booting.

5.If your camera is under a DHCP server, DHCP server will assign an IP automatically. Use IP Installer to find it. If you do not have a DHCP server, the default IP address of camera is 192.168.10.30. Default username is "admin" and password is "admin".

© Copyright 2014 TRENDnet. All Rights Reserved.

33

Image 34

Contents TRENDnet User’s Guide Contents Product Hardware Features Package ContentsFeatures Product OverviewApplication Diagram Camera ConnectorsHardware Installation InstallationShield Installation LED Indicator Camera InstallationBracket Installation WaterproofingTV-IP302PI TV-IP302PI Configuration Viewing Camera Basic Function     Configuring the Camera Setting System System System Information OSD SettingSystem System Information Server Information System System Information Time Setting System User Management ∙ Direct Video Stream Authentication∙ Configuration ∙ Enable Password Protection∙ Firmware Upgrade System ToolsNetwork Network Setting Port Setting Network Network Setting IP Address SettingNetwork Network Setting IPv6 Setting Network Network Setting Web Authentication∙ Rtsp Authentication Network Network Setting UPnP ∙ UPnPNetwork Network Setting Rtsp Setting ∙ Rtsp Server ∙ UPnP Port Forwarding∙ Security Network Network Setting OnvifNetwork Network Setting Bonjour ∙ Rtsp KeepaliveNetwork Advanced Https Network Advanced Snmp ∙ SNMPv3 ∙ SNMPv1/SNMPv2 Trap Network Advanced IP Address Filter Network Advanced QoS/DSCPNetwork Advanced Ieee Network PPPoE & Ddns ∙ PPPoEDdns Status ∙ Mail Setting Network Event Server∙ FTP Setting ∙ Samba SettingAudio/Video Setting Image Setting TRENDnet User’s Guide Audio/Video Setting Video Setting ∙ Basic Mode of Streaming 1 and Streaming∙ 3GPP Streaming mode ∙ Advanced Mode of Streaming 1 and StreamingAudio/Video Setting Audio Setting Event Configuration Event Configuration Motion DetectionEvent Configuration Motion Detection Record Time Setting Event Configuration Motion Detection Record FileEvent Configuration Motion Detection Network IP Check Event Configuration Schedule ∙ On/Off Switch mode Gpio Setting Event Configuration Gpio Setting Input SettingOutput Test Factory Default ∙ Time Switch modeHow to Access the IP camera via IP Installer How to setup/access the camera behind a Router Configure Ddns on your CameraConfigure Ddns on your router Protocol Select TCPCamera login page will appear Video Features Technical SpecificationsHardware Management Interface Camera SoftwareWindows Vista TroubleshootingWindows XP Forgot my password. What should I do? Limited Warranty Limited Warranty