TRENDnet TV-IP302PI manual Forgot my password. What should I do?

Page 42

TRENDnet User’s Guide

b.If you are using non-IE browser (Firefox, Chrome, Safari), make sure that you install the plug-in WebPlugin.exe.

6.How do I uninstall the browser’s Active X or Plug-in from my computer?

Click Computer Icon, type in “np_hoem_x.dll” on the top-right corner of the search bar, then click “Search”.

Delete the file named "np_hoem_x.dll" from search result.

Search for the additional ActiveX or plug-in files listed below and delete them to completely uninstall the ActiveX control or plug-in from your computer.

∙avcodec-53_v1.8.dll

∙avutil-51_v1.8.dll

∙swscale-2_v1.8.dll

∙WEBWATCH2

∙WEBWATCH2.ocx

TV-IP302PI

7.I forgot my password. What should I do?

Please follow the steps below to reset to factory default setting

a.Remove the power and network cable

b.Take the included Reset Wire Cable, plug one side of the wire into "Default" and the other side into "GND" on the terminal block as shown below.

c.Connect power to the camera again. It takes around 30 seconds to boot the camera.

d.Remove the wire and plug in the network cable after the camera finishes booting.

e.Run the Install Camera wizard from the CD-ROM to login to the camera.

© Copyright 2014 TRENDnet. All Rights Reserved.

41

Image 42

Contents TRENDnet User’s Guide Contents Product Hardware Features Package ContentsFeatures Product OverviewApplication Diagram Camera ConnectorsInstallation Hardware InstallationShield Installation LED Indicator Camera InstallationBracket Installation WaterproofingTV-IP302PI TV-IP302PI Configuration Viewing Camera Basic Function     Configuring the Camera Setting System System Information OSD Setting SystemSystem System Information Server Information System System Information Time Setting System User Management ∙ Direct Video Stream Authentication∙ Configuration ∙ Enable Password Protection∙ Firmware Upgrade System ToolsNetwork Network Setting Port Setting Network Network Setting IP Address SettingNetwork Network Setting IPv6 Setting Network Network Setting Web Authentication∙ Rtsp Authentication Network Network Setting UPnP ∙ UPnPNetwork Network Setting Rtsp Setting ∙ Rtsp Server ∙ UPnP Port Forwarding∙ Security Network Network Setting OnvifNetwork Network Setting Bonjour ∙ Rtsp KeepaliveNetwork Advanced Https Network Advanced Snmp ∙ SNMPv3 ∙ SNMPv1/SNMPv2 Trap Network Advanced IP Address Filter Network Advanced QoS/DSCPNetwork Advanced Ieee Network PPPoE & Ddns ∙ PPPoEDdns Status ∙ Mail Setting Network Event Server∙ FTP Setting ∙ Samba SettingAudio/Video Setting Image Setting TRENDnet User’s Guide Audio/Video Setting Video Setting ∙ Basic Mode of Streaming 1 and Streaming∙ Advanced Mode of Streaming 1 and Streaming ∙ 3GPP Streaming modeAudio/Video Setting Audio Setting Event Configuration Event Configuration Motion DetectionEvent Configuration Motion Detection Record File Event Configuration Motion Detection Record Time SettingEvent Configuration Motion Detection Network IP Check Event Configuration Schedule Gpio Setting Event Configuration Gpio Setting Input Setting ∙ On/Off Switch modeOutput Test Factory Default ∙ Time Switch modeHow to Access the IP camera via IP Installer How to setup/access the camera behind a Router Configure Ddns on your CameraConfigure Ddns on your router Protocol Select TCPCamera login page will appear Technical Specifications Video FeaturesHardware Management Interface Camera SoftwareTroubleshooting Windows VistaWindows XP Forgot my password. What should I do? Limited Warranty Limited Warranty