TRENDnet TV-IP302PI manual Application Diagram, Camera Connectors

Page 4

TRENDnet User’s Guide

TV-IP302PI

Application Diagram

Camera Connectors

Speaker	GPIO	Ethernet /PoE	Microphone	BNC	Power
Out	Port	Port	In	Video Out	Connector
	Port		In	Video Out	Connector

∙Power Connector: Connects the power adapter to supply power to the camera if using non-PoE connection

∙BNC Video Out: Connect a CRT monitor or handheld monitor.

∙Microphone In: Connects an external microphone to receive the on-the-spot sound where the camera is installed.

∙Ethernet/PoE Port: Plugs the network cable to connect to your local area network (LAN). If you are using the PoE, you must have the network cable connect to your PoE switch or PoE Injector.

∙GPIO Port: Connect external device. Please refer to I/O setting paragraph. It's also used for IP camera reset. Please refer to Factory Default paragraph.

∙Speaker Out: Connects an external audio device (such as the active speaker) to deliver sound via the camera.

© Copyright 2014 TRENDnet. All Rights Reserved.

3

Image 4

Contents TRENDnet User’s Guide Contents Package Contents FeaturesProduct Hardware Features Product OverviewApplication Diagram Camera ConnectorsHardware Installation InstallationShield Installation Camera Installation Bracket InstallationLED Indicator WaterproofingTV-IP302PI TV-IP302PI Configuration Viewing Camera Basic Function     Configuring the Camera Setting System System System Information OSD SettingSystem System Information Server Information System System Information Time Setting System User Management ∙ Direct Video Stream Authentication∙ Enable Password Protection ∙ Firmware Upgrade∙ Configuration System ToolsNetwork Network Setting IP Address Setting Network Network Setting IPv6 SettingNetwork Network Setting Port Setting Network Network Setting Web AuthenticationNetwork Network Setting UPnP ∙ UPnP Network Network Setting Rtsp Setting ∙ Rtsp Server∙ Rtsp Authentication ∙ UPnP Port ForwardingNetwork Network Setting Onvif Network Network Setting Bonjour∙ Security ∙ Rtsp KeepaliveNetwork Advanced Https Network Advanced Snmp ∙ SNMPv3 ∙ SNMPv1/SNMPv2 Trap Network Advanced IP Address Filter Network Advanced QoS/DSCPNetwork Advanced Ieee Network PPPoE & Ddns ∙ PPPoEDdns Status ∙ Mail Setting Network Event Server∙ FTP Setting ∙ Samba SettingAudio/Video Setting Image Setting TRENDnet User’s Guide Audio/Video Setting Video Setting ∙ Basic Mode of Streaming 1 and Streaming∙ 3GPP Streaming mode ∙ Advanced Mode of Streaming 1 and StreamingAudio/Video Setting Audio Setting Event Configuration Event Configuration Motion DetectionEvent Configuration Motion Detection Record Time Setting Event Configuration Motion Detection Record FileEvent Configuration Motion Detection Network IP Check Event Configuration Schedule ∙ On/Off Switch mode Gpio Setting Event Configuration Gpio Setting Input SettingOutput Test Factory Default ∙ Time Switch modeHow to Access the IP camera via IP Installer How to setup/access the camera behind a Router Configure Ddns on your CameraConfigure Ddns on your router Protocol Select TCPCamera login page will appear Video Features Technical SpecificationsHardware Management Interface Camera SoftwareWindows Vista TroubleshootingWindows XP Forgot my password. What should I do? Limited Warranty Limited Warranty