TRENDnet TV-IP302PI manual Camera login page will appear

Page 38

TRENDnet User’s Guide

3.Find the Dynamic DNS configuration section.

4.Enable DDNS, fill out the following information and then click Apply.

TV-IP302PI

5.Go to Virtual Server* section and create a new entry. Enable: Click Enable

Name: Enter the application name (eg. Camera Name)

Protocol: Select TCP

Private Port: The HTTP port that you assign on your Camera.

Public Port: The port used on remote side to access to your Camera.

LAN Server: The local IP address of your Camera.

Click Add to add the application.

*Please refer to your router’s user’s manual for detail Virtual Server setting. Some router might use Port Forwarding or Special applications for this function. The setup steps should be very similar.

6.Open another web browser and enter your DDNS domain and camera’s port number.

http://yourDomainName:PortNumber

7.The camera login page will appear.

© Copyright 2014 TRENDnet. All Rights Reserved.

37

Image 38

Contents TRENDnet User’s Guide Contents Product Hardware Features Package ContentsFeatures Product OverviewApplication Diagram Camera ConnectorsShield Installation InstallationHardware Installation LED Indicator Camera InstallationBracket Installation WaterproofingTV-IP302PI TV-IP302PI Configuration Viewing Camera Basic Function     Configuring the Camera Setting System System Information Server Information System System Information OSD SettingSystem System System Information Time Setting System User Management ∙ Direct Video Stream Authentication∙ Configuration ∙ Enable Password Protection∙ Firmware Upgrade System ToolsNetwork Network Setting Port Setting Network Network Setting IP Address SettingNetwork Network Setting IPv6 Setting Network Network Setting Web Authentication∙ Rtsp Authentication Network Network Setting UPnP ∙ UPnPNetwork Network Setting Rtsp Setting ∙ Rtsp Server ∙ UPnP Port Forwarding∙ Security Network Network Setting OnvifNetwork Network Setting Bonjour ∙ Rtsp KeepaliveNetwork Advanced Https Network Advanced Snmp ∙ SNMPv3 ∙ SNMPv1/SNMPv2 Trap Network Advanced IP Address Filter Network Advanced QoS/DSCPNetwork Advanced Ieee Network PPPoE & Ddns ∙ PPPoEDdns Status ∙ Mail Setting Network Event Server∙ FTP Setting ∙ Samba SettingAudio/Video Setting Image Setting TRENDnet User’s Guide Audio/Video Setting Video Setting ∙ Basic Mode of Streaming 1 and StreamingAudio/Video Setting Audio Setting ∙ Advanced Mode of Streaming 1 and Streaming∙ 3GPP Streaming mode Event Configuration Event Configuration Motion DetectionEvent Configuration Motion Detection Network IP Check Event Configuration Motion Detection Record FileEvent Configuration Motion Detection Record Time Setting Event Configuration Schedule Output Test Gpio Setting Event Configuration Gpio Setting Input Setting∙ On/Off Switch mode Factory Default ∙ Time Switch modeHow to Access the IP camera via IP Installer How to setup/access the camera behind a Router Configure Ddns on your CameraConfigure Ddns on your router Protocol Select TCPCamera login page will appear Hardware Technical SpecificationsVideo Features Management Interface Camera SoftwareWindows XP TroubleshootingWindows Vista Forgot my password. What should I do? Limited Warranty Limited Warranty