Viking Access Systems H-10 manual Post Mounting Option

Page 17

GATE OPERATOR INSTALLATION

Post Mounting Option

TIP: The operator is equipped for post mount applications and is ready for installation. You will only need to supply the posts and u-bolts.

1. Consult the local building codes for the depth and concrete requirements.

2.Maximum 3.00” OD pipe.

3.Provide a sufficient number of conduit pathways for all low power acces- sories such as loop detector leads, maglock, non-contact sensors, contact sensors, safety and other commands. Also provide conduit for the power supply to the operator.

!DO NOT run low voltage and high voltage wiring in the same conduit.

!Provide at least 12” separation between low and high voltage conduits.

VIKING TECHNICAL SUPPORT 1.800.908.0884	1 5

Image 17

Contents Instructions Viking H-10 Slide Gate Operator Vehicular Gate Operator Revision H10NXMN10.E December Description Parts DiagramOperator References Control Board References EMI Board ConnectorTable of Contents Important Safety Instructions Important Safety InformationImportant Installation Instructions Maintenance Glossary UL325 Gate Operator ClassificationsSecondary Entrapment Protection Photo Beam non-contact sensor InstallationManual Release Edge Sensor contact sensor InstallationWhen manual operation is required Manual Reset for the Audible Alarm Audible Alarm Reset Switch InstallationSingle Phase 50 Hz / 60 Hz SpecificationsAlternative Power 24VAC / VDC 60VA or Solar Locate Control ButtonsConcrete Pad Option Gate Operator InstallationPost Mounting Option Operator Positioning Step High Voltage Supply Option Electrical InstallationTips for proper ground installation Solar Supply Option Low Voltage Supply Option1a 1b Limits SetupTo Readjust the Close Limit To Readjust the Open LimitMS1 MS2 MASTER/SLAVE SetupTwo Wire Communication Required ADD-ON Choose option a or B Wireless Communication OptionsObstruction Detection Sensor Initial SettingsTimer Hold Open Timer Auto Open Power Failure Option Control Board SetupLast Open Power Failure Option Fail Safe/SecureODS Obstruction Detection Sensor Obstruction Sensor Primary Entrapment ProtectionViking Heater Viking Lock ModeThis page Left Blank Intentionally Re-Open Photo Beam vehicular Safety Accessory ConnectionsCOM + Check for proper operationOpen Only Radio Receiver TypicalOpen-Stop-Close Open Commands Anti-Tailgate, Open Commands & Guard StationGuard Station ATG Anti-TailgateViking Loop Rack Guidelines for Loop Installation Accessory ConnectionsMagnetic Lock Lock Solenoid Power for the LocksMagnetic Lock, Lock Solenoid Barrier Arm B-12 Synchronization Option Synchronization with B-12LED References TroubleshootingTroubleshooting LCD Display References LCD MSG MeaningTroubleshooting Error Messages Check SolutionsPower Connections Access Control ConnectionsRelays In General Appendix aGeneral Technical TIP Viking usesCommon Radio Receivers Connections Solar Applications Appendix CPanels Batteries & FuseViking Konnect Master/Slave Kit Secure and reliable Viking Konnect Diagnostic Tool On-site remoteViking Expansion Products OUR Continuous Commitment to Excellence Standard Features