TROUBLESHOOTING
LCD Display References
The control board is equipped with a LCD Display that provides operator information, current conditions, settings, diagnostics and error messages. Use the table below to identify the corresponding “TS Ref#” and refer to page 41 for further troubleshooting.
1. Error Messages will be displayed first.
2. The ”Diagnose” LED will flash consecutively indicating how many Error Messages are available.
3. Press the Diagnose button to manually scroll through all of the Messages.
LCD MSG Meaning | Page 41 |
TS Ref #s |
VIKING | Welcome Message | |
ACCESS | ||
| ||
MODEL | Indicates the Model of the unit | |
H10 | ||
| ||
| System Status Messages |
GATE IS IDLE
GATE IS OPENING
GATE IS CLOSING
GATE IS OPENED
GATE IS CLOSED
STOP BY OBSTRUCT
STOP BY OVERLOAD
OVERLAP TIMING
HOLDING __ SEC
EPS2
OK
Gate is stopped between limits
Gate is opening
Gate is closing
Gate is at the limit open position
Gate is at the limit close position
Gate stopped due to an obstruction sensor event
Gate stopped due to an overload of the gate system
Gate is waiting for the overlap time
Gate is at the limit open position and timing to close - The display shows the actual time left before closing
While the gate is running, indicates the percentage of accuracy of the EPS. “OK” indicates 100% accurate communication
11, 12, 13
11, 12
3 8 | VIKING TECHNICAL SUPPORT 1.800.908.0884 |
|
|