Viking Access Systems H-10 manual Standard Features

Page 50

STANDARD FEATURES

AND OPERATOR SPECIFICATIONS

•UL Listed; UL325 and UL991

•ETL Listed; UL325 and UL991

•Externally accessible Manual Release Switch

•Fail-Safe option sets the gate to automatically transfer to a fail-safe mode in the event of a power failure, allowing the gate to be pushed open without the use of special knowledge of the equipment

•Fail- Secure option sets the gate to electronically lock in the event of a power failure, allowing no manual movement without the use of the manual release

•Elegant design, appealing to any architectural project

•Plated and powder coated steel chassis

•Adjustable travel speed

•Up to 75’ maximum gate opening

•100% duty cycle

•Modular Power Supply Box for convenient low voltage installations

•100 cycles of operation on backup battery

(1000 lb. gate and 20’ length)

•Intelligent speed control with smooth start and stop, self-adjust system

•Anti-Tailgate and Operation Pre-Warming features

•On-Board LCD Display provides diagnostics, operator status, settings and real-time volt and amp readings

•Intelligent obstruction detection with adjustable sensitivity

•Built-in climate control for cold weather applications

•Built-in protection against lightning strikes or similar electrical surges

•Regulated power supply for your external accessories

•Inherent overload protection; redundancy design using multiple types of protection

•Modular connectors for easy access control and accessory installation

•Solar panel and low voltage wiring compatibility

•LED indicators display gate and operator status for easy troubleshooting

INSTALLATION DATE: __________________________________

COMPANY / INSTALLER: ________________________________

CONTACT: __________________________________________

SERIAL NUMBER(S): ____________________________________

ALL INSTALL ATION , MAINTENANCE AN D REPAIR WORK M UST B E DOCU M ENTED AN D MADE AVAIL AB LE TO THE USER .

VIKING ACCESS SYSTEMS

631 Wald Irvine, CA 92618

Phone 800.908.0884

Fax 949.753.1640

www.vikingaccess.com

Image 50

Contents Instructions Viking H-10 Slide Gate Operator Vehicular Gate Operator Revision H10NXMN10.E December Parts Diagram DescriptionOperator References EMI Board Connector Control Board ReferencesTable of Contents Important Safety Information Important Safety InstructionsImportant Installation Instructions Maintenance UL325 Gate Operator Classifications GlossaryPhoto Beam non-contact sensor Installation Secondary Entrapment ProtectionManual Release Edge Sensor contact sensor InstallationWhen manual operation is required Audible Alarm Reset Switch Installation Manual Reset for the Audible AlarmAlternative Power 24VAC / VDC 60VA or Solar SpecificationsSingle Phase 50 Hz / 60 Hz Locate Control ButtonsGate Operator Installation Concrete Pad OptionPost Mounting Option Operator Positioning Step High Voltage Supply Option Electrical InstallationTips for proper ground installation Low Voltage Supply Option Solar Supply OptionLimits Setup 1a 1bTo Readjust the Open Limit To Readjust the Close LimitMS1 MS2 MASTER/SLAVE SetupTwo Wire Communication Wireless Communication Options Required ADD-ON Choose option a or BObstruction Detection Sensor Initial SettingsTimer Hold Open Timer Last Open Power Failure Option Control Board SetupAuto Open Power Failure Option Fail Safe/SecureObstruction Sensor Primary Entrapment Protection ODS Obstruction Detection SensorViking Lock Mode Viking HeaterThis page Left Blank Intentionally COM + Accessory ConnectionsRe-Open Photo Beam vehicular Safety Check for proper operationOpen Only Radio Receiver TypicalOpen-Stop-Close Guard Station Anti-Tailgate, Open Commands & Guard StationOpen Commands ATG Anti-TailgateViking Loop Rack Accessory Connections Guidelines for Loop InstallationMagnetic Lock Lock Solenoid Power for the LocksMagnetic Lock, Lock Solenoid Synchronization with B-12 Barrier Arm B-12 Synchronization OptionTroubleshooting LED ReferencesTroubleshooting LCD MSG Meaning LCD Display ReferencesTroubleshooting Error Messages Solutions CheckAccess Control Connections Power ConnectionsGeneral Appendix aRelays In General Technical TIP Viking usesCommon Radio Receivers Connections Panels Appendix CSolar Applications Batteries & FuseViking Konnect Master/Slave Kit Secure and reliable Viking Konnect Diagnostic Tool On-site remoteViking Expansion Products OUR Continuous Commitment to Excellence Standard Features