Viking Access Systems H-10 manual Viking Expansion Products

Page 48

VIKING EXPANSION PRODUCTS

VIKING KONNECT Master/Slave Kit Secure and reliable

Master/Slave communication using Viking’s Konnect technology. Paired with the Viking App, each module also doubles as a diagnostic tool.

Part# VA-KONNECT-MS

***Q-7, B-12 & ECU Operators require (2) Antenna Extension Cables (part# VA-RPSMA)***

VIKING KONNECT Diagnostic Tool On-site remote

access to the operator from the convenience of a compatible hand held device. With the Viking App, this tool becomes a wireless extension

of the control board allowing you to view and change settings, review diagnostic information, operate the gate for testing and update the control boards firmware. Part# VA-KONNECT-D

***Q-7, B-12 & ECU Operators require (1) Antenna Extension Cable (part# VA-RPSMA)***

VIKING MONITOR Off-site access to operator diagnostics and perform firmware updates from just about anywhere with cellular service. With the Viking App, this tool allows you to monitor and label multiple operators by site and location for quick reference. Provides error notifications, operator status, settings and diagnostic information.

Part# VA-MONITOR

***Q-7, B-12 & ECU Operators require (1) Antenna Extension Cable (part# VA-RPSMA)***

VIKING APP Mobile device user interface application for Viking Konnect and Viking Monitor. Available for iOS, Android and Windows operating systems. Free for download from your mobile device application store or www.vikingaccess.com

VIKING AC SURGE PRO Adds another layer of protection to the high voltage power supply of your gate operator. Connecting the AC Surge Pro in parallel to the EMI Board, provides a dual layer of protection from surges up to 20,000 Volts / 10,000 Amps. Part# VA-SURGEPROAC

VIKING SOLAR KIT The components included in this package are intended to provide sufficient power for general applications.

Part# VA-SOCHP

This Kit includes the following components:

(2)12V 40W Solar Panels Part# VA-SO40W(wired in series = 24V 80W)

(2)

12V 35Ah batteries

Part# DUBA35 (wired in series = 24V 35Ah)

(1)

Solar Charger

Part# SOCHR10

(1)

Solar Power Harness

Part# SOHAR

!NOTE: The number of cycles achieved from this kit are dependent upon the following and may require increased panel and battery capacities:

• Power consumption of all accessories being used

• Average solar radiation of geographic location

4 6

VIKING TECHNICAL SUPPORT 1.800.908.0884

 

 

Image 48
Contents Instructions Viking H-10 Slide Gate Operator Vehicular Gate Operator Revision H10NXMN10.E December Parts Diagram DescriptionOperator References EMI Board Connector Control Board ReferencesTable of Contents Important Safety Information Important Safety InstructionsImportant Installation Instructions Maintenance UL325 Gate Operator Classifications GlossaryPhoto Beam non-contact sensor Installation Secondary Entrapment ProtectionEdge Sensor contact sensor Installation When manual operation is requiredManual Release Audible Alarm Reset Switch Installation Manual Reset for the Audible AlarmSpecifications Single Phase 50 Hz / 60 HzAlternative Power 24VAC / VDC 60VA or Solar Locate Control ButtonsGate Operator Installation Concrete Pad OptionPost Mounting Option Operator Positioning Step Electrical Installation Tips for proper ground installationHigh Voltage Supply Option Low Voltage Supply Option Solar Supply OptionLimits Setup 1a 1bTo Readjust the Open Limit To Readjust the Close LimitMASTER/SLAVE Setup Two Wire CommunicationMS1 MS2 Wireless Communication Options Required ADD-ON Choose option a or BInitial Settings Timer Hold Open TimerObstruction Detection Sensor Control Board Setup Auto Open Power Failure OptionLast Open Power Failure Option Fail Safe/SecureObstruction Sensor Primary Entrapment Protection ODS Obstruction Detection SensorViking Lock Mode Viking HeaterThis page Left Blank Intentionally Accessory Connections Re-Open Photo Beam vehicular SafetyCOM + Check for proper operationRadio Receiver Typical Open-Stop-CloseOpen Only Anti-Tailgate, Open Commands & Guard Station Open CommandsGuard Station ATG Anti-TailgateViking Loop Rack Accessory Connections Guidelines for Loop InstallationPower for the Locks Magnetic Lock, Lock SolenoidMagnetic Lock Lock Solenoid Synchronization with B-12 Barrier Arm B-12 Synchronization OptionTroubleshooting LED ReferencesTroubleshooting LCD MSG Meaning LCD Display ReferencesTroubleshooting Error Messages Solutions CheckAccess Control Connections Power ConnectionsAppendix a Relays In GeneralGeneral Technical TIP Viking usesCommon Radio Receivers Connections Appendix C Solar ApplicationsPanels Batteries & FuseViking Konnect Diagnostic Tool On-site remote Viking Expansion ProductsViking Konnect Master/Slave Kit Secure and reliable OUR Continuous Commitment to Excellence Standard Features