Viking Access Systems H-10 manual Viking Heater, Viking Lock Mode

Page 29

CONTROL BOARD SETUP

Viking Heater

The operator has an integrated heater that is thermostatically controlled. Activate this feature when the operator is used in application temperatures down to -20°F (-29°C).

To set the heater to turn on at the Close Limit:

1.Use the “Diagnose” button to scroll through the LCD Display to “HEATER CLS”

2.Press and hold the “Stop” button on the control board.

3.Press and release the “Diagnose” button to turn this feature ON and OFF.

To set the heater to turn on at the Open Limit:

1.Use the “Diagnose” button to scroll through the LCD Display to “HEATER OPN”

2.Perform steps 2-3 as described above.

HEATER CLS ON

HEATER OPN ON

NOTE: If the application requires the gate to be held open for any reason, set the HEATER ON for both limit positions.

!IMPORTANT: A POSITIVE STOP must be used on the gate at the limit position(s) the HEATER has been set for.

Viking Lock Mode

Turning this feature ON will secure the gate at the closed position, preventing unauthorized manual entry.

Use the LCD Display to activate this feature.

1.Use the “Diagnose” button to scroll through the LCD menu to “LOCK MOD”

2.Press and hold the “Stop” button on the control board.

3.Press and release the “Diagnose” button to turn this feature ON and OFF.

LOCK MOD ON

VIKING TECHNICAL SUPPORT 1.800.908.0884	2 7

Image 29

Contents Instructions Viking H-10 Slide Gate Operator Vehicular Gate Operator Revision H10NXMN10.E December Description Parts DiagramOperator References Control Board References EMI Board ConnectorTable of Contents Important Safety Instructions Important Safety InformationImportant Installation Instructions Maintenance Glossary UL325 Gate Operator ClassificationsSecondary Entrapment Protection Photo Beam non-contact sensor InstallationManual Release Edge Sensor contact sensor InstallationWhen manual operation is required Manual Reset for the Audible Alarm Audible Alarm Reset Switch InstallationSingle Phase 50 Hz / 60 Hz SpecificationsAlternative Power 24VAC / VDC 60VA or Solar Locate Control ButtonsConcrete Pad Option Gate Operator InstallationPost Mounting Option Operator Positioning Step High Voltage Supply Option Electrical InstallationTips for proper ground installation Solar Supply Option Low Voltage Supply Option1a 1b Limits SetupTo Readjust the Close Limit To Readjust the Open LimitMS1 MS2 MASTER/SLAVE SetupTwo Wire Communication Required ADD-ON Choose option a or B Wireless Communication Options Obstruction Detection Sensor Initial Settings Timer Hold Open Timer Auto Open Power Failure Option Control Board SetupLast Open Power Failure Option Fail Safe/SecureODS Obstruction Detection Sensor Obstruction Sensor Primary Entrapment ProtectionViking Heater Viking Lock ModeThis page Left Blank Intentionally Re-Open Photo Beam vehicular Safety Accessory ConnectionsCOM + Check for proper operationOpen Only Radio Receiver TypicalOpen-Stop-Close Open Commands Anti-Tailgate, Open Commands & Guard StationGuard Station ATG Anti-TailgateViking Loop Rack Guidelines for Loop Installation Accessory ConnectionsMagnetic Lock Lock Solenoid Power for the LocksMagnetic Lock, Lock Solenoid Barrier Arm B-12 Synchronization Option Synchronization with B-12LED References TroubleshootingTroubleshooting LCD Display References LCD MSG MeaningTroubleshooting Error Messages Check SolutionsPower Connections Access Control ConnectionsRelays In General Appendix aGeneral Technical TIP Viking usesCommon Radio Receivers Connections Solar Applications Appendix CPanels Batteries & FuseViking Konnect Master/Slave Kit Secure and reliable Viking Konnect Diagnostic Tool On-site remoteViking Expansion Products OUR Continuous Commitment to Excellence Standard Features