Viking Access Systems H-10 manual Table of Contents

		TABLE OF CONTENTS:
	PARTS DIAGRAM/PARTS LIST
			2
OPERATOR REFERENCES
			3
CONTROL BOARD REFERENCES
			4
	IMPORTANT SAFETY INFORMATION			6-12
	Important Safety Instructions		6
	Important Installation Instructions		7
	Maintenance		8
	General Safety Precautions		8-9
	Operator Classification		9
	Photo Beam (non-contact sensor) Installation		10
	Edge Sensor (contact sensor) Installation		11
	Manual Release		11
	Audible Alarm Reset Installation		12
	Warning Placard Installation		12
	IMPORTANT INSTALLATION INFORMATION
			13
	Specifications		13
GATE OPERATOR INSTALLATION
			14-17
	Concrete Pad Option		14
	Post Mounting Option		15
	Operator Positioning		16-17
	ELECTRICAL INSTALLATION		18-19
	High Voltage Supply Option		18
	Low Voltage Supply Option		19
	Solar Supply Option		19
	LIMITS SETUP		20-21
	MASTER/SLAVE SET UP
			22-23
	Two Wire Communication		22
	Wireless Communication Options		23
CONTROL BOARD SETUP		24-27
	Initial Settings		24-25
	Obstruction Detection Sensor (Primary Entrapment Protection)		26
	Heater, Lock Mode................................................................................................................. 27
ACCESSORY CONNECTIONS			29-35
	Re-Open Photo Beam (Vehicular Safety)		29
	Radio Receiver (Typical)		30
	Anti-Tail Gate, Open Commands, Guard Station		31
	Viking Loop Rack		32
	Guidelines for Loop Installations		33
	Magnetic Lock, Lock Solenoid		34
	Barrier Arm (B-12) Synchronization Option		35
TROUBLESHOOTING
			36-41
	LED References		36-37
	LCD Display References		38-40
	Solutions		41
APPENDIX A, B & C
			42-45
VIKING EXPANSION PRODUCTS
			46

VIKING TECHNICAL SUPPORT 1.800.908.0884 5