Bosch Appliances MIC412 operation manual Fitting the optional Sunshield

Page 19

MIC412TI and MIC412TF Camera Installation and Operation Manual

3.Break the two wire links and remove any excess solder.

4.Solder the wire links using a soldering iron and TCW link wire from the left hand pads to the middle pads.

5.The power supply will now deliver +18vac to HD6.

6.Connect the heater wires (brown and gray) from the shielded composite cable to the HD6 terminal as labelled on the PCB.

7.The heaters are thermostatically controlled and will automatically turn on at +5°C (+41°F) and turn off at +15°C (+59°F).

8.Check all connections, re-seal the PSU enclosure and re-apply power.

EN 19

Fitting the optional Sunshield

The MIC412 Sunshield is designed to provide additional protection against direct solar radiation, it is a two (2) part moulding and comes supplied with eight (8) stainless steel bosses and eight (8) M3 washers and retaining screws. The sunshield is fitted in the following manner:-

1.Remove the four (4) retaining bolts from the lid of the MIC 412, DO NOT remove the lid as this will void the warranty.

2.Replace each retaining screw with one of the stainless steel bosses and tighten using a flat head screwdriver in the slot on top of each boss.

3.When all four (4) bosses have been fitted, line up the holes in the sunshield with the bosses.

4.Fix the sunshield to the bosses using the M3 stainless steel washers and screws.

5.Rotate the MIC412 under power (Do not rotate by hand) and repeat the procedure above on the lower lid of the MI C412.

Bosch Security Systems

Issue 8

Image 19

Contents MIC412 Dual Optical / Thermal PTZ Camera MIC 412 Dual Optical / Thermal PTZ Camera Power Supply Installation and Camera Setup… Safety Precautions Important Safety Instructions Glossary of Appendices Glossary of TermsIntroduction MIC412 Camera Versions MIC 412 Power Supply Unit Versions and OptionsWiper FeaturesPackaging Contents MIC 412 OptionsInstallation Environment Bosch Security Systems Issue Key to MIC-PMB drawing Associated Equipment and Typical InstallationsInstallation Instructions Hardware InstallationLightning Protection Earthing of the MIC 412 cameraElectrical Connections PCB Earth Link MIC 412TI and MIC 412TF Power Supply UnitsPower Supply Layout and Connections MIC-24PSU-UL, MIC-115PSU-UL, and MIC-240PSU-ULTable D -Telemetry Connections to HD3, HD4 and HD5 HD3Rating for 115v Primary Terminal Box ConnectorTerminal Box ID Marking Fuse Fuse function Rating for 240v PrimaryCommissioning the MIC 412 with heater option fitted Fitting the optional Sunshield Connecting the KK systems K2-ADE RS232 to RS485/422 Adaptor Connecting the MIC 412 to the PCConnecting the Greenwich Adaptor Table G Connecting the Greenwich AdaptorConnecting the MIC-USB485CVTR, USB to RS485 Converter Table I Camera Interface Control Settings DIP SwitchCamset Tabs Wire RS485 Wire RS422 HD4 or HD5 MIC-USB485CVTR and Universal Camset Software InstallationStandard Controls Boot MessagesMIC Settings Commissioning the MIC412 through Universal CamsetCamset Settings Manual Control Pan, Tilt and Zoom Controls Auxiliaries Preset PositionsIris Controls Focus ControlsTour Controls Preset ToursPattern Tours Clear MIC SetupsSoft Stops and Non Dwell Zones Non-Dwell ZoneGeneral Settings Other controls Auto Home ControlsDefault Settings Relay State, Activation and Re-arm Multi Alarm SettingsLearn Alarm Positions Frame Integration SettingsPrivacy Controls Privacy and CaptionsPrivacy Calibration Captions Gain and Auto Gain Modes FFC Mode and SettingsThermal Shutter Open/CloseClear All Statistics Advanced SettingsTemperature and Humidity TimersUpload Eeprom From File Eeprom CopierOnly Download Eeprom To FileMatrix Controls Manual and Preset / Goto ControlsPOT Test Menu Controls Panasonic OnlyVisible Traces Pot Test ControlsPot Test Results CommsMouse Point Values Send Direct Command Cam Comms Communications TestingAlarms MIC CommsSonySet Controls Get Preset from MICSend Preset to MIC Sony SetClear Table Execute this PresetLoad Table from File to MIC Save Table from MIC to FileTable K Sonyset Commands Value MIC Programmer Bosch Security Systems Issue Learning a preset Help MIC412 Preset Codes for the Thermal ImagerBosch Protocol Aux Number Aux On Function Aux Off Function Go to a preset36x optical zoom module MIC412TI and TF Dual Optical/Thermal PTZ CameraConnectivity Dimension Drawings Appendix a Sonyset Camera CommandsMIC 412 models Upright 90 Dimension Drawings Pelco Appendix B Protocol Preset CodesWashwipeonpreset Washwipeoffpreset Vision Special Setup PresetsAmerican Dynamics Special Setup Presets Kalatel Molynx Autoironpreset Autoiroffpreset Multialarmonpreset Panasonic Bosch Forward Vision Intermitantwipeonpreset Intermitantwipeoffpreset VCL Vicon Rightpreset Softlimitbottom Multialarmpreset Bosch Security Systems Inc Contact AmericasEurope, Middle East, Africa Asia-PacificBosch Security Systems, Inc