Optiview TRKPTZ-18NX, TRKPTZ -26NX user manual Zone Setting, Clear Pattern

Page 34

Auto Zooming Tracking Dome Camera User Manual

(2)Move the joystick up or down to view selections. Press iris Open to confirm selection.

(3)Move joystick to position the cursor beside PROGRAM PATTERN.

(4)Press iris Open.

(5)Follow the directions displayed on the monitor.

After a pattern is programmed, the remaining storage percentage will be displayed on the screen. This is the amount of memory available to program the remaining patterns.

CLEAR PATTERN:

(1)Move joystick to position the cursor beside CLEAR PATTERN.

(2).Press iris Open.

(3)F0llow the directions displayed on the monitor.

3.5.7Zone Setting

Move joystick to select <ZONES>, then press Open to enter the zones menu shown as Fig 3.14.

ZONES
ZONE NUMBER	1

…ZONE NOT DEFINEO… <EDIT ZONE LABEL> <EDIT ZONE>

ZONE ENABLED ON <CLEAR ZONE >

BACK

EXIT

Figure 3.14 ZONES SETTING

33

Image 34

Contents Auto Zooming Tracking Dome Cameras Contents Dome Label Other Functions Production Introducing CharacterFunction Description Page Page Random Scan Alarms Alarms input Specification Comparison Chart Auto trackingAGC 18X 22X 23X Normal Operation Menu Configuration PTOL：PELCO-D Main Menu Select LanguageSystem Information System InformationDisplay Setup 3.4.1 Display Setup Label Position Dome Settings Camera SettingsProgram AE Mode Backlight Compensation BLCAE Mode LOW Light ModeAGC Level LOW Light LimitIris Level Bright LevelIR CUT Filter Other MenuShutter 8A Other Menu Auto IrisAuto Sharpness Auto White BalanceMotion Setting Auto FilpPark Time Proportional PANPark Action Clear Scan Stops Scan SpeedSET Scan Stops SET Manual LimitSET Azimuth Zero Power UpPower UP Action Clear Azimuth ZeroPresets Setting Select preset number Edit preset labelClear a preset Patterns SettingEdit preset scene Programe PatternZone Setting Clear PatternTo program a zone To edit a zone labelTo clear a zone Clears SettingClear Zones Clear Presets Presets NumberDome Settings 2 Menu Restore Factory DefaultsReset Delaysecs AlarmsAlarm Number SequencesecsSelect alarm number Alarms SettingSelect alarm priority Set alarm action Set alarm contact Aux SettingSet auxiliary to activate Password Setting Enable Password Windows Blanking StyleSet Windows Blanking ParametersEdit Windows Location Operation27 Edit Windows Pan the joystick to adjust the zoom times Edit Windows ZoomTemperature SET Heater SettingHeater Mode Heater DisplayCruise Setting Tracking Setting Page Tracking Boundary Dome Label Reset CameraReboot System Other Functions