Optiview TRKPTZ-18NX, TRKPTZ -26NX user manual Windows Blanking, Style

Page 44

Auto Zooming Tracking Dome Camera User Manual

3.6.5 Windows Blanking

Move joystick to select <WINDOWS BLANKING>, then press Open to enter the windows blanking menu shown as Fig 3.23.

WINDOWS BLANKING

STYLE

GRAY

BLANK ALL ABOVE

OFF

BALANK ALL BELOW

OFF

<SET WINDOWS>

 

BACK

 

EXIT

 

Figure 3.22 WINDOWS BLANKING

Window blanking enables you to program up to eight, four-sided, user-defined areas that cannot be viewed by the operator of the dome system. A blanked area will move with pan and tilt functions and automatically adjust in size according to zoom times.

Style:

The dome has two styles for window blanking, GRAY and SMEAR. If style is set to gray, the blanked area is covered with a solid gray window. If smear is selected images behind the window will be noticeable but not distinguishable.

BLANK ALL ABOVE/BLANK ALL BELOW:

The dome camera has two style modes for window blanking, GRAY and SMEAR. If style is set to gray, the blanked area is covered with a solid gray window. If smear is selected images behind the window will be noticeable but not distinguishable.

43

Image 44
Contents Auto Zooming Tracking Dome Cameras Contents Dome Label Other Functions Production Introducing CharacterFunction Description Page Page Random Scan Alarms Alarms input Specification Comparison Chart Auto trackingAGC 18X 22X 23X Normal Operation Menu Configuration PTOL:PELCO-D Main Menu Select LanguageSystem Information System InformationDisplay Setup 3.4.1 Display Setup Label Position Dome Settings Camera SettingsProgram AE Mode Backlight Compensation BLCAE Mode LOW Light ModeLOW Light Limit Iris LevelAGC Level Bright LevelShutter Other MenuIR CUT Filter 8A Other Menu Auto IrisAuto Sharpness Auto White BalanceMotion Setting Auto FilpPark Action Proportional PANPark Time Scan Speed SET Scan StopsClear Scan Stops SET Manual LimitPower Up Power UP ActionSET Azimuth Zero Clear Azimuth ZeroPresets Setting Select preset number Edit preset labelPatterns Setting Edit preset sceneClear a preset Programe PatternZone Setting Clear PatternTo program a zone To edit a zone labelClear Zones Clears SettingTo clear a zone Presets Number Dome Settings 2 MenuClear Presets Restore Factory DefaultsAlarms Alarm NumberReset Delaysecs SequencesecsSelect alarm priority Alarms SettingSelect alarm number Set alarm action Set auxiliary to activate Aux SettingSet alarm contact Password Setting Enable Password Windows Blanking StyleSet Windows Blanking ParametersEdit Windows Location Operation27 Edit Windows Pan the joystick to adjust the zoom times Edit Windows ZoomHeater Setting Heater ModeTemperature SET Heater DisplayCruise Setting Tracking Setting Page Tracking Boundary Reset Camera Reboot SystemDome Label Other Functions