About the ID of the Remote Commander
You can avoid having the digital camcorder accidentally respond to signals from other remote commanders by setting the VTR4/ID/VTR2 switch to ID. Use the supplied Remote Commander when you set the switch to ID. When you use the Remote Commander for the first time, register the ID following the procedure below. Once you have registered the ID, you do not need to do so again.
(1) Install a power source, open the cover, then press MENU to display the menu in the
viewfinder. |
| |
(2) Press | or | to select COMMANDER, then press EXECUTE. |
(3) Press | or | to select ID SET. |
(4) Set VTR4/ID/VTR2 on the Remote Commander to ID.
(5) Point the Remote Commander at the Remote Commander sensor on the digital camcorder and press ¹ on the Remote Commander.
After the beep sound, the ID of the Remote Commander is registered, and the COMMANDER is set to ID in the menu system.
(6) Press MENU to erase the menu display.
Before you begin
1
5
MENU
STOP
MENU |
|
| |
D ZOOM | OFF |
| |
ZEBRA |
|
| |
COMMANDER |
|
| |
BEEP |
|
| |
FRAME REC |
|
| |
INT REC |
|
| |
SLOW SHTR |
|
| |
[ MENU ] : END |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
2 MENU
COMMANDER VTR4
OFF
ID
ID SET
[ MENU ] : END
3 MENU
COMMANDER VTR4
OFF
ID
ID SET
COMMANDER [ STOP ] : ID SET
4 VTR 4 ID VTR 2
13