•24 V AC power supply connector kit (accessory)
Recommended specification of cable (wire)
Wire size | #24 | #22 | #20 | #18 |
(AWG), | (0.22 mm) | (0.33 mm) | (0.52 mm) | (0.83 mm) |
stranded |
|
|
|
|
wire |
|
|
|
|
|
|
|
|
|
Length of | 20 m | 30 m | 45 m | 75 m |
cable | {65.62 feet} | {98.43 feet} | {147.64 feet} | {246.06 feet} |
|
|
|
|
|
Power supply connector housing (accessory)
Pin No. Signal
1 24 V AC LIVE (Brown)
2 24 V AC NEUTRAL (Blue)
3 Ground (Green)
4 Not use
•How to assemble the 24 V AC power supply con- nector kit
Remove approx. 3 mm {1/8 inches} of the outer jacket of the cable and twist the cable core to prevent the short cir- cuit first.
Insert the tip of the cable into the point A of the contact (accessory), and hold the cable using the cable clamp.
|
| Approx. 3 mm {1/8 inches} | Cable |
|
|
| |
| Upper | A |
|
Contact | side |
|
|
(accessory) | Insert |
| |
Procure either of the following tools for clamping. Molex manual clamp tool:
Upper side | Cable |
|
Contact (accessory)
Power supply connector housing (accessory)
IMPORTANT:
•Conduct the electric conduit work after processing the power supply connector and making sure that the camera is operating normally.
• Network cable
Connect a LAN cable (category 5e or better) to the net- work connector.
IMPORTANT:
•Use all 4 pairs (8 pins) of the LAN cable.
•The maximum cable length is 100 m {328 feet}.
•Make sure that the PoE+ device in use is compliant with IEEE802.3at standard.
•When connecting both of the 24 V AC power supply and the PoE+ device for power supply, 24 V AC will be used for power supply.
If a 24 V AC power supply and a PoE (or PoE+) hub or router are used at the same time, network connec- tions may not be possible. In this case, disable the PoE settings. Refer to the operating instructions of the PoE (or PoE+) hub or router in use.
•When disconnecting the LAN cable once, reconnect the cable after around 2 seconds. When the cable is quickly connected, the power may not be supplied from the PoE+ device.
•Output cable for the monitor used for adjustment
Connect a coaxial cable (BNC) (only for checking if images are displayed on the monitor).
This output is provided only for checking the adjustment of the angular field of view on the video monitor when installing the camera or when servicing.
IMPORTANT:
•The monitor out connector for adjustment is provided only for checking the adjustment of the angular field of view on the video monitor when installing the cam- era or when servicing. It is not provided for recording/ monitoring use.
•Black bands may appear at the top and bottom or right and left of the screen. (That does not affect the adjustment because the angular field of view is not changed.)
27