Panasonic WV-SW598 Live indicator keeps on, Blinking orange approx, Seconds intervals, Use

Symptom	Cause/solution	Reference
		pages
	• UPnPTM error has occurred since the power is not supplied to the
	router.	−
	Turn on the power of the router. Wait until the connections are
	established.
Live indicator keeps on	• An error has occurred during the port update by the UPnP func-	Operating
	tion.
blinking orange approx. in 2		Instructions
	If the router in use does not support the UPnP function, perform
seconds intervals.		(included in
	the port forwarding setting for the router. In addition, deactivate the
		the CD-ROM)
	setting of auto port forwarding for the camera.
	• UPnP function of the router is disabled.
	Refer to the operating instructions of the router to enable the	−
	UPnP function.
	• Is “Off” selected for “Link/Access LED” on the “Basic” page?	Operating
		Instructions
Live indicator never lights up.	Select “On” or “On(Access)” for the indicator setting.
		(included in
		the CD-ROM)
	• The camera may be out of order.
Live indicator keeps on	Contact your dealer.
	• Refer to the readme file on the provided CD-ROM for further infor-	−
blinking red.
	mation after checking the displayed contents of the “Maintenance”
	page - the [Status] tab - “Self check” of the setup menu.
	• Isn’t the write protect switch of the inserted SD memory card set
	to “LOCK”?
	Unlock the write protect switch of the SD memory card.
	• Hasn't the inserted SD memory card been formatted on a PC?	Operating
	Use an SD memory card formatted on the camera.
		Instructions
Live indicator lights red.	Or install the software to format the SD memory card on the PC.
		(included in
	Refer to our website
		the CD-ROM)
	(http://security.panasonic.com/pss/security/support/info.html)
	for further information about the supported software.
	• Isn't the inserted SD memory card faulty?
	Replace the card with a normal one.
	• Check the following.
	• Grounding of the camera, a switching hub or peripheral devices
	are not done.
	• The camera is used near an electrical power line.
Audio input contains noise.	• The camera is used near a device which produces strong mag-	13
	netic field or radio waves (such as near a TV/radio antenna, a
	motor of an air conditioning system, a transformer, etc.)
	When audio input still contains noise even after checking the
	above possibilities, use a powered microphone or connect audio
	output with low output impedance.
The power cable insulation is
damaged.	The power cable and connectors are worn out.
The power cable, plug and
	This may result in electric shock or a fire.
connectors get hot during		–
	Unplug the power cable from the AC outlet immediately, and refer
use.
	to qualified service personnel.
The power cable gets hot
when bent or stretched.

34