Procure fixing screws separately, Router

Procure fixing screws separately.

The screws that secure this product are not supplied. Prepare them according to the mate- rial and strength of the area where the product is to be installed.

Do not remove or loosen the screws on the rear of this product.

If the screws (7 pcs.) are loosened, water expo- sure may cause damage or malfunction of the product, or dropping may result in injury.

Radio disturbance

When this product is used near TV/radio antenna, strong electric field or magnetic field (near a motor, a transformer or a power line), images may be distorted and noise sound may be produced.

Installing in low temperature environments This product can be used in low temperature outdoor environments that get as cold as -40 °C {-40 °F}. However, when this product is used in temperatures below -10 °C {14 °F}, snow and frost on the dome cover may not come off. Also when this product is installed and operated in temperatures below -20 °C {-4 °F}, normal images may not be obtained immediately after startup. In such a case, con- nect the power and wait approx. 2 hours, and then connect the power again.

PoE (Power over Ethernet)

Use a PoE hub/device that is compliant with IEEE802.3af standard.

Router

When connecting this product to the Internet, use a broadband router with the port forward- ing function (NAT, IP masquerade).

Refer to the Operating Instructions on the pro- vided CD-ROM for further information about the port forwarding function.

Time & date setting

It is necessary to set the time & date before putting this product into operation. Refer to the Operating Instructions on the provided CD-ROM for descriptions of how to perform the settings.

Influence on images and their quality This product has no wiper unit. Under the fol- lowing conditions, image quality may deterio- rate or images may not be viewed properly.

•Affects of rainfall

Due to the wind that accompanies rainfall, raindrops may fall on the dome cover. That may make images less viewable.

•Affects of snowfall

Due to the wind that accompanies snow- fall, snow may fall on the dome cover. That may partially make surveillance images inviewable. (The extent of inviewability may vary depending on the amount of snowfall and the quality of snow.)

•Affects of dust in the air or gas emission from vehicles

Depending on the installation environment, dome cover may be dirty due to dust in the air or gas emission from vehicles. That may degrade the quality of images.

•Affects of strong light

When the camera is facing toward a spot light or other bright lights and light reflect- ing objects, ghost images (a phenomenon where objects that do not actually exist appear in images) may appear. In particu- lar, ghost images may be more noticeable when the camera is facing toward an LED light.