Panasonic WV-SW458E, WV-SW458ME Use the bit for tamperproof screw accessory

Page 33

b Accommodate the connected cables inside the cable guide of the camera mount bracket.

IMPORTANT:

• To prevent the cables from being caught when the base cover (accessory) is attached, keep the cables inside the cable guide.

Cable guide

Connected cable

Cable guide

n Attach the base cover (accessory) that was removed according the steps in page 20.

 

Base cover

 

(accessory)

m Use the bit for tamperproof screw (accessory)

Base cover fixing screws

to tighten the fixing screws provided on both

 

sides of the base cover (accessory).

 

(Recommended tightening torque:

 

0.78 N·m {0.58 lbf·ft})

,Remove the cover film from the dome cover.

33

Image 33
Contents Model No. WV-SW458/WV-SW458M WV-SW458E/WV-SW458ME WV-SW458E, WV-SW458ME Contents Important safety instructions Limitation of liability Disclaimer of warrantyPreface About notationsMain functions CPU System requirements for a PCCopyright Trademarks and registered trademarksNetwork security Precautions Turn the power off when cleaning this product Do not damage the power cablePrecautions for use This product has no power switch Cleaning this product bodyCode label Mount bracket accessory SW458Discoloration on the color filter of the MOS image sensor Indication labelInstalling place Precautions for installationDo not place this product in the following places About the network connectionProcure fixing screws separately Time & date settingRadio disturbance RouterMajor operating controls About the Initial SET button About the indicators inside the SD memory card slot coverPreparations Mounting hole pattern Using the side cable access hole SW458MInstalling the camera directly on the ceiling or wall SW458M Using the mount bracket accessory SW458 Ø1-1/16 inches Cable access hole For use of the hole Camera attachment accessory Fixing screws accessory Insert/remove an SD memory card Connection Power cableWV-SW458 WV-SW458MAlarm OUT, AUX OUT AlarmRatings Terminal name When using PoE IEEE802.3af compliant When using 12 V DC power supply*1LAN cable How to wind the supplied waterproof tapeRequired cable Using a two-gang junction box InstallationUsing the mount bracket SW458 Page Use the bit for tamperproof screw accessory Configuring the camera so that it can be accessed from a PC Configure the network settingsPage When using DC power supply TroubleshootingLimited Power Source SpecificationsAlarm in 1, Alarm in 2/ Alarm OUT BasicELC ATW1/ ATW2/ AWCViqs Lens NetworkJpeg IGMP, ICMP, ARP Jpeg MjpegOptional accessories Standard accessoriesPage Page For business users in the European Union For U.S. and CanadaPGQX1203YA