Panasonic WV-SW458E, WV-SW458ME installation instructions Configure the network settings

Page 34

Configure the network settings

Configuring the camera so that it can be accessed from a PC

The following are descriptions for when the camera with default settings is configured. If you are using firewall software on your PC, the Setup Program may not be able to find any cameras on your network. Configure the setting of the camera after temporarily invalidating the firewall software. Contact the network administrator or your Internet service provider for information about configuring the settings of the network.

zInsert the provided CD-ROM into the CD-ROM drive of your PC.

•The License Agreement will be displayed. Read the Agreement and choose “I accept the term in the license agreement”, and click [OK].

•The launcher window will be displayed. If the launcher window is not displayed, double click the “CDLauncher.exe” file on the CD-ROM.

Note:

•Refer to “Using the CD-ROM” in the Operating Instructions on the provided CD-ROM for further information about CDLauncher.

xClick the [Run] button next to [IP Setting Software].

“Panasonic IP Setting Software” page will be displayed. Click the [Network Settings] button after selecting the MAC address/IP address of the camera to be configured.

34

Image 34

Contents Model No. WV-SW458/WV-SW458M WV-SW458E/WV-SW458ME WV-SW458E, WV-SW458ME Contents Important safety instructions Disclaimer of warranty Limitation of liabilityAbout notations PrefaceMain functions System requirements for a PC CPUTrademarks and registered trademarks CopyrightNetwork security Precautions Precautions for use This product has no power switch Do not damage the power cableTurn the power off when cleaning this product Cleaning this product bodyDiscoloration on the color filter of the MOS image sensor Mount bracket accessory SW458Code label Indication labelDo not place this product in the following places Precautions for installationInstalling place About the network connectionRadio disturbance Time & date settingProcure fixing screws separately RouterMajor operating controls About the indicators inside the SD memory card slot cover About the Initial SET buttonPreparations Using the side cable access hole SW458M Mounting hole patternInstalling the camera directly on the ceiling or wall SW458M Using the mount bracket accessory SW458 Ø1-1/16 inches Cable access hole For use of the hole Camera attachment accessory Fixing screws accessory Insert/remove an SD memory card WV-SW458 Power cableConnection WV-SW458MAlarm Alarm OUT, AUX OUTRatings Terminal name When using 12 V DC power supply*1 When using PoE IEEE802.3af compliantHow to wind the supplied waterproof tape LAN cableRequired cable Installation Using a two-gang junction boxUsing the mount bracket SW458 Page Use the bit for tamperproof screw accessory Configure the network settings Configuring the camera so that it can be accessed from a PCPage Troubleshooting When using DC power supplyAlarm in 1, Alarm in 2/ Alarm OUT SpecificationsLimited Power Source BasicATW1/ ATW2/ AWC ELCViqs Network LensJpeg Jpeg Mjpeg IGMP, ICMP, ARPStandard accessories Optional accessoriesPage Page For U.S. and Canada For business users in the European UnionPGQX1203YA