Panasonic WV-SW458E, WV-SW458ME Troubleshooting, When using DC power supply

Page 36

Troubleshooting

Before asking for repairs, check the symptoms with the following table.

Contact your dealer if a problem cannot be solved even after checking and trying the solution in the table or a problem is not described below.

Symptom

Cause/solution

Reference

pages

 

 

 

 

 

 

When using DC power supply

 

 

• Is 12 V DC power supply connected to the 2P

 

 

power supply cable?

 

 

Check whether the connection is appro-

 

 

priately established.

 

 

• Is the AC adaptor in use compliant with the

 

 

Specifications?

 

 

Check the Specifications regarding AC

 

 

adaptor.

 

Power is not turned on.

When using a PoE device for power supply

27

 

 

 

• Are the PoE device and the network cable of

 

 

the camera connected using a LAN cable?

 

 

Check whether the connection is appro-

 

 

priately established.

 

 

• Depending on the PoE device, the power sup-

 

 

ply will stop when the demanded power

 

 

exceeds its total power limit for all PoE ports.

 

 

Refer to the operating instructions of the

 

 

PoE device in use.

 

 

 

 

36

Image 36
Contents Model No. WV-SW458/WV-SW458M WV-SW458E/WV-SW458ME WV-SW458E, WV-SW458ME Contents Important safety instructions Disclaimer of warranty Limitation of liabilityPreface About notationsMain functions System requirements for a PC CPUTrademarks and registered trademarks CopyrightNetwork security Precautions Do not damage the power cable Turn the power off when cleaning this productPrecautions for use This product has no power switch Cleaning this product bodyMount bracket accessory SW458 Code labelDiscoloration on the color filter of the MOS image sensor Indication labelPrecautions for installation Installing placeDo not place this product in the following places About the network connectionTime & date setting Procure fixing screws separatelyRadio disturbance RouterMajor operating controls About the indicators inside the SD memory card slot cover About the Initial SET buttonPreparations Using the side cable access hole SW458M Mounting hole patternInstalling the camera directly on the ceiling or wall SW458M Using the mount bracket accessory SW458 Ø1-1/16 inches Cable access hole For use of the hole Camera attachment accessory Fixing screws accessory Insert/remove an SD memory card Power cable ConnectionWV-SW458 WV-SW458MAlarm OUT, AUX OUT AlarmRatings Terminal name When using 12 V DC power supply*1 When using PoE IEEE802.3af compliantHow to wind the supplied waterproof tape LAN cableRequired cable Installation Using a two-gang junction boxUsing the mount bracket SW458 Page Use the bit for tamperproof screw accessory Configure the network settings Configuring the camera so that it can be accessed from a PCPage Troubleshooting When using DC power supplySpecifications Limited Power SourceAlarm in 1, Alarm in 2/ Alarm OUT BasicELC ATW1/ ATW2/ AWCViqs Lens NetworkJpeg Jpeg Mjpeg IGMP, ICMP, ARPStandard accessories Optional accessoriesPage Page For business users in the European Union For U.S. and CanadaPGQX1203YA