Panasonic WV-SW458E, WV-SW458ME Using the mount bracket accessory SW458

Using the mount bracket (accessory) SW458

Note:

•When the camera is mounted on the ceiling or wall with a hole for cable running, or the camera is mounted using open wiring, the mount bracket (accessory) is used.

IMPORTANT:

•If open wiring is conducted, be sure to use conduits and run the cables inside the tubes to protect the

cables from direct sunlight.

• Installation work shall be such that there is no exposure to water into the architecture through the conduits hav- ing been joined.

Conduit

z Loosen two fixing screws on both ends of the base cover (accessory) by using the bit for tam- perproof screw (accessory), and remove the base cover (accessory).

When using a conduit, use a hexagon wrench (ISO 2936, width across flats S=5 mm {5/64 inches}) or other tool and also remove the cap for the female thread for the conduit.

Note:

•The female thread for the conduit is compliant with ANSI NPSM (parallel pipe threads)

3/4 inch or G3/4 of ISO 228-1.

Base cover ￿xing screws

Mount bracket (accessory)

Base cover (accessory)

Cap for the female thread for the conduit

20