Precautions for installation
Panasonic assumes no responsibility for injuries or property damage resulting from fail- ures arising out of improper installation or operation inconsistent with this documenta- tion.
This product is designed to be installed under eaves.
Install the product under eaves to avoid direct sunlight.
Installing place
Contact your dealer for assistance if you are unsure of an appropriate place in your particu- lar environment.
•Make sure that the installation area is strong enough to hold this product, such as a concrete ceiling.
•Install the camera in the foundation area of the architecture or where sufficient strength is assured.
•If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced.
Do not place this product in the following places:
•Locations where a chemical agent is used such as a swimming pool
•Locations subject to moisture or oil smoke such as a kitchen
•Locations that have a specific environment that is subject to an inflammable atmo- sphere or solvents
•Locations where a radiation, an
•Locations where corrosive gas is pro- duced, locations where it may be damaged by briny air such as seashores
•Locations where the temperature is not within the specified range (page 37)
•Locations subject to vibrations that exceed the railway specifications (EN50155)
Do not install this product in a humid or
Otherwise, lifetime of the internal parts may be shortened.
Be sure to remove this product if it is not in use.
Shielded (STP) LAN cables must be used with this unit to ensure compliance with EMC standards. *
* E models only
Design and engineer the power supply system to turn on/off the power of this product.
The product has no power switch. When installing the product, use a power supply device equipped with the
About the network connection
When connecting to a network using the net- work cable of this product, observe the follow- ing.
•When wiring for the network, design and engineer not to be affected by thunder.
Screw tightening
•The screws and bolts must be tightened with an appropriate tightening torque according to the material and strength of the installation area.
•Do not use an impact driver. Use of an impact driver may damage the screws or cause tightening excessively.
•Tighten screws at a right angle to the sur- face. After tightening screws, perform checks to ensure that the tightening is suf- ficient enough so that there is no move- ment or looseness.
13