Panasonic WV-SW458E, WV-SW458ME installation instructions Preparations

Preparations

When installing the camera on a ceiling or a wall, there are 3 methods as specified below.

• Using a two-gang junction box (☞ pages 18 and 19)

• Installing the camera directly on the ceiling or wall SW458M (☞ page 19)

• Using the supplied mount bracket SW458 (☞ pages 20 to 23)

IMPORTANT:

• Procure 4 screws (M4) to secure the camera attachment (accessory) or the mount bracket (accessory) SW458 to a ceiling or a wall according to the material of the installation area. Do not use wood screws and nails.

For mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4) for securing. (Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft})

•Mount the camera attachment (accessory) in consideration of the camera angle in accordance with the instructions (☞ pages 18 and 19).

•Required pull-out capacity of a single screw/bolt is 196 N {44 lbf} or more.

•If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced.

The mounting conditions of the camera are described as follows:

Installation	Appropriate mount	Recommended	Number of	Minimum pull-out
place	bracket	screw	screw	strength (per 1 pc.)
Ceiling/wall	Two-gang junction box	M4	4 pcs.	196 N {44 lbf}
SW458M	(Direct mounting)	M4	4 pcs.	196 N {44 lbf}
Ceiling/wall
SW458	Mount bracket (accessory)	M4	4 pcs.	196 N {44 lbf}
Ceiling/wall*

* The conditions for securing the mount bracket to a ceiling or a wall are described here.

17