Axis Communications Q1635 user manual Replace the Lens

AXIS Q1635 Fixed Network Camera

Hardware Overview

•When the camera is not level, the LEDs flash a combination of red, green and orange, and the beep occurs at slow intervals. Both LEDs briefly flash green to indicate that the levelling is getting better.

Replace the Lens

It is possible to use optional lenses for the Axis product.

To replace the lens:

1.Disconnect the iris cable.

2.Unscrew the standard lens.

3.Attach and screw on the new lens. To change the iris configuration:

1.Go to Setup > Video and Audio > Camera Settings. Iris configuration shows the current configured iris type.

2.Click Edit.

3.Select the installed iris lens from the drop-down list and click OK.

To change the iris configuration for P-iris lenses not listed in the drop-down list:

1.Download the iris configuration file from www.axis.com

2.Go to Setup > Video and Audio > Camera Settings. Iris configuration shows the current configured iris type.

3.In Iris configuration : Click Edit.

4.Go to the Upload tab.

5.Click Browse and select the configuration file.

6.Click Upload. The installed iris lens should now be included in the Iris Selection drop-down list.

7.Select the installed iris lens from the drop-down list and click OK.

Note

•If you select a DC iris configuration file for a P-iris lens, an error message will appear below the iris configuration type in the Camera Settings page. For custom DC Iris lenses, select Generic DC Iris option.

•There is no need to restart the product after changing the lens. However, the product must be restarted if you are interchanging between a P-iris, DC-Iris or fixed/manual iris lens. In order to set the focus and position the lens, the product must be connected to the network.

10