Security Escort Technical Reference Manual 3.0 System Menus and Screens
EN 30
Auto Silence Alarm In X Seconds
This box determines the length of time that the sirens and horns sound before being automatically silenced by the central console. When the sounders are automatically silenced in this way, the central console remains in its Alarm Mode. The numerical value is in seconds and it can be set between 0 and 9999. Typically, this value is set to prevent violating local noise ordinances. It defaults to 240 seconds (4 minutes.).
Recall Operator In X Seconds
This box determines the length of time before a recall alert is issued to the operator at the central console when an alarm displays. If neither the mouse nor any key was actuated for the specified length of time, the central console resounds the alarm sound once. This feature prevents inadvertently ignoring an active alarm event. The numerical value is in seconds that can be set between 0 and 240. Typically this would be set to 60 seconds.
On Outside Tests Flash Strobe For X Seconds
The entry in this box controls the approximate length of time the strobe on an alert unit flashes to signify a successful transmitter test. The value is in seconds, and can be set between 0 and 15. Typically, it is set to 5 seconds.
Man Down Delay Timer X Seconds
This value controls the time that a transmitter must be in a man down condition before a man down alarm displays. Typically, it is set to 10 seconds. Setting this value too short causes inadvertent man down alarms to be generated.
Man down jitter timer ‘X’ Seconds
This value controls the time that a transmitter will not be considering any man down alarm if man down alarm is received immediately after restore and before jitter time expire. This setting will not be used in normal system.
Auto Reset Comm Ports ‘X’ Hours
This value controls the time that all the comm ports in the system will be automatically reset after configured duration. This setting is used only if any communication failure is observed and should not be used unnecessarily.
End Of Shift Reminder
A check in this box causes a prompt to appear on the central console each 5 min. for 30 min. prior to the end of each shift if there are Incident Reports that were not yet completed. Responding officers should complete Alarm Reports before the end of their shift.
First, Second, Third Shift Reminder
The entries in these fields are the times
Database Find Level
This is the minimum receive level (1 to
255)that must be heard before the system automatically enters the transmitter in the Subscriber Locate Screen. It determines the distance the subscriber’s transmitter must be within the specified ID capture receiver (set in the System Preferences Screen) before the system recognizes the test.
Locate Test Level
This is the minimum receive level (1 to
255)that must be heard before the system accepts a test generated by a transmitter other than a guard, to be printed with a location. It determines the distance the transmitter must be from a receiver before the system recognizes the test and prints the location. If the transmitter is too far away from the receiver, that receiver’s green light does not display, and the guard knows to move closer to the receiver for the test to register.
Guard Tour Level
This is the minimum receive level (1 to
255)that must be heard before the system accepts a test generated by the guard’s transmitter to be entered as a location in the Guard Tour Report. It determines the distance the guard’s transmitter must be from a receiver before the system recognizes the test and creates the guard tour entry. If the guard is too far away from the receiver, that receiver’s green light does not display and the guard knows to move closer to the receiver for the test to register.
Bosch Security Systems 6/12 38947D