Security Escort Technical Reference Manual 3.0 System Menus and Screens
EN 47
Tamper Map
This button requests a map of all the devices on this transponder (receivers or alert units) that are reporting a tamper condition to the system. The current troubles list is automatically updated.
Acknowledge
Clicking this button removes all restored troubles from the current troubles list.
AC Loss Map
This button requests a map of all the alert units on this transponder that are reporting an AC loss condition to the system. The current troubles list is automatically updated.
Refresh Data
Clicking this button updates all of the transponder level data in this screen. It does not update the device troubles (use stress test or auto scan to update the device troubles).
Reset Transponder Troubles
The Reset Transponder Troubles button is used to reset all of the alarm, test and message counters to zero, and to remove any restoration reports.
Low Battery Map
This button requests a map of all the alert units on this transponder that are reporting a low battery condition to the system. The current troubles list is automatically updated.
3.3.11Transponder Parameter Change Screen
This screen allows parameters stored in the transponder’s EEPROM memory to be viewed and changed.
Figure 444: Transponder Parameter Change Screen
Run Silent
If checked, the receivers and alert units on this transponder do not sound an alarm. This includes alarms received during a communications failure with the central console.
Optional Parameter
This is a future option, leave unchecked.
Loop Communications
When this option is checked, the communications to the transponders are wired in a loop. The output from the computer goes to the input of the first transponder. The output from the first transponder goes to the input of the second transponder, and so on until the output from the last transponder in the loop goes to the input of the computer. This form of communications allows fiber optic communications to be used (with third party fiber to
Enable Remote Key
If checked, the remote key supervised input on this transponder is enabled; otherwise, it is ignored.
Uses Proxim Radio
Only check this item if a Proxim radio is used to communicate to the central console.
Comm Fail to Siren Out
If this item is checked, the siren output on this transponder activates when a communications failure is detected at the central console.
Verbose Point Reports
If checked, alarm and test reports include average levels and packet count information. This extra information is for diagnostic proposes only and is not required for system operation. Since the additional data increases the system traffic load leave this item unchecked.
Test Min Level
This is the minimum receive level (1 to
255)a receiver must see before the green light displays acknowledging a successful test. Leave this item at default (128).
Bosch Security Systems 6/12 38947D