Datalogic Scanning I GD4100 manual Disable Character Setting Examples

RS-232/USB-Com Interfaces

Disable Character

Specifies the value of the RS-232 host command used to disable the reader.

ASCII characters or any hex value from 0 to 0xFF can be selected.

NOTE

Setting to previously defined characters such as XON, XOFF, or host commands conflicts with normal operation of these characters. 8-bit data is not recognized when the option Data Bits has been set as 7 Data Bits.

To set the value:

1.Determine the desired character or value. A setting of 0xFF indicates the Disable Charac- ter is not used (not available).

2.Use the ASCII Chart on the inside back cover of this manual to find the hex equivalent for the desired character/value.

3.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.

4.Scan the barcode: SELECT DISABLE CHARACTER SETTING.

5.Scan the appropriate two alpha-numeric characters from the keypad in Appendix E, Key- pad, that represent the desired character/value in step 1 above. The second character will cause a two-beep indication.

6.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.

This completes the procedure. See Table 12 for some examples of how to set this feature.

	Table 12. Disable Character Setting Examples
STEP	ACTION			EXAMPLES
1	Desired character/value	‘d’	‘}’	‘D’	Disable Command
					Not Used
2	Hex equivalent	0x64	0x7D	0x44	0xFF
3	Scan ENTER/EXIT PROGRAMMING MODE
4	Scan SELECT DISABLE CHARACTER VALUE SETTING
5	Scan Two Characters From	‘6’ and ‘4’	‘7’ and ‘D’	‘4’ and ‘4’	‘F’ AND ‘F’
	Appendix E, Keypad
6	Scan ENTER/EXIT PROGRAMMING MODE

74 Gryphon™ I GD4100