
GS1 DataBar™ Expanded
GS1 DataBar™ Expanded — cont.
GS1 DataBar™ Expanded Set Length 2
This feature specifies one of the barcode lengths for GS1 DataBar™ Expanded Length Control. Length 2 is the maximum label length if in Variable Length Mode, or the second fixed length if in Fixed Length Mode. Length includes the barcode’s data characters only.
The length can be set from 1 to 74 characters. A setting of 0 specifies to ignore this length (only one fixed length).
Follow these instructions to set this feature:
1.Determine the desired character length (from 1 to 74). Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
2.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
3.Scan the barcode: SELECT GS1 DataBar™ EXPANDED LENGTH 2 SETTING.
4.Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent the length setting which was determined in the steps above. You will hear a
If you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start again at the beginning.
NOTE
5.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See Table 20 for some examples of how to set this feature.
Table 20. GS1 DataBar™ Expanded Length 2 Setting Examples
STEP | ACTION |
| EXAMPLES |
| ||
1 | Desired Setting | 00 (ignore second | 07 Characters | 52 Characters | 74 Characters | |
length) | ||||||
|
|
|
|
| ||
2 |
| Scan ENTER/EXIT PROGRAMMING MODE |
| |||
3 | Scan SELECT GS1 DataBar™ EXPANDED LENGTH 2 SETTING |
| ||||
4 | Scan Two Characters From | ‘0’ and ‘7’ | ‘5’ and ‘2’ | ‘7’ and ‘4’ | ||
Appendix E, Keypad | ‘0’ and ‘0’ | |||||
|
|
|
|
| ||
5 |
| Scan ENTER/EXIT PROGRAMMING MODE |
|
Product Reference Guide | 167 |