Wedge Quiet Interval
Wedge Quiet Interval
This option specifies the amount of time to look for keyboard activity before the reader breaks the keyboard connection in order to transmit data to host. The selectable range for this feature is from 0 to 990ms in 10ms increments.
This feature applies ONLY to the Keyboard Wedge interface.
NOTE
Follow these instructions to set this feature:
1.Determine the desired setting in milliseconds.
2.Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead- ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
4.Scan the barcode: SELECT WEDGE QUIET INTERVAL SETTING.
5.Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent the duration which was determined in the steps above. You will hear a
If you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start again at the beginning.
NOTE
6.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure to set the Wedge Quiet Interval. See Table 14 for some examples of how to set this feature.
| Table 14. Timeout Setting Examples |
|
| |||
STEP | ACTION |
|
| EXAMPLES |
| |
1 | Desired Setting | 10ms | 150ms | 600ms | 850ms | |
2 | Divide by 10 (and pad with | 01 | 15 | 60 | 85 | |
leading zeroes) | ||||||
|
|
|
|
| ||
3 | Scan ENTER/EXIT PROGRAMMING MODE |
| ||||
4 | Scan SELECT WEDGE QUIET INTERVAL SETTING |
| ||||
5 | Scan Two Characters From | ‘0’ and ‘1’ | ‘1’ and ‘5’ | ‘6’ and ‘0’ | ‘8’ and ‘5’ | |
Appendix E, Keypad | ||||||
|
|
|
|
| ||
Product Reference Guide | 85 |
