| Table of Contents |
Introduction | 7 |
About this Guide | 7 |
Manual Overview | 7 |
Manual Conventions | 8 |
References | 8 |
Technical Support | 9 |
Datalogic Website Support | 9 |
Reseller Technical Support | 9 |
Telephone Technical Support | 9 |
Getting Started | 11 |
About the Reader | 11 |
Unpacking | 11 |
Setting Up the Reader | 11 |
Install the Interface Cable | 12 |
Programming | 14 |
Using the Programming Barcodes | 14 |
Select the Interface Type | 15 |
Configure Interface Settings | 15 |
Configure Other Features | 15 |
Resetting the Standard Product Defaults | 15 |
Interfaces | 17 |
Interface Selection | 17 |
Configuring the Interface | 17 |
Global Interface Features | 21 |
Host Commands — Obey/Ignore | 21 |
USB Suspend Mode | 22 |
General Features | 23 |
Double Read Timeout | 23 |
Label Gone Timeout | 25 |
Sleep Mode Timeout | 27 |
LED and Beeper Indicators | 29 |
Power On Alert | 29 |
Good Read: When to Indicate | 30 |
Good Read Beep Type | 31 |
Good Read Beep Frequency | 32 |
Good Read Beep Length | 32 |
Good Read Beep Volume | 34 |
Good Read LED Duration | 35 |
Scanning Features | 37 |
Scan Mode | 37 |
Stand Mode Triggered Timeout | 39 |
Stand Detection | 41 |
Scanning Active Time | 42 |
Flash On Time | 44 |
Flash Off Time | 46 |
Stand Mode Sensitivity | 47 |
Stand Detection | 48 |
Green Spot Duration | 49 |
51 | |
Introduction | 51 |
51 | |
Baud Rate | 52 |
Data Bits | 54 |
Stop Bits | 55 |
Parity | 56 |
Handshaking Control | 57 |
Product Reference Guide | 1 |
