Datalogic Scanning I GD4100 manual ACK Character Setting Examples

RS-232/USB-Com Interfaces

ACK Character

This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII characters or any hex value from 0 to 0xFF can be selected.

NOTE

Setting to previously defined characters such as XON, XOFF, or host commands conflicts with normal operation of these characters. 8-bit data is not recognized when the option Data Bits has been set as 7 Data Bits.

To set this feature:

1.Determine the desired character or value.

2.Use the ASCII Chart on the inside back cover of this manual to find the hex equivalent for the desired character/value.

3.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.

4.Scan the barcode: SELECT ACK CHARACTER SETTING.

5.Scan the appropriate two alpha-numeric characters from the keypad in Appendix E, Key- pad, that represent the desired character/value in step 1 above. The second character will cause a two-beep indication.

6.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.

This completes the procedure. See Table 8 for some examples of how to set this feature.

	Table 8. ACK Character Setting Examples
STEP	ACTION			EXAMPLES
1	Desired Character/Value	ACK	$	@	>
2	Hex equivalent	0x06	0x24	0x40	0x3E
3	Scan ENTER/EXIT PROGRAMMING MODE
4		Scan SELECT ACK CHARACTER SETTING
5	Scan Two Characters From		‘2’ and ‘4’	‘4’ and ‘0’	‘3’ AND ‘E’
	Appendix E, Keypad	‘0’ and ‘6’
6	Scan ENTER/EXIT PROGRAMMING MODE

64 Gryphon™ I GD4100