Datalogic Scanning I GD4100 manual Install the Interface Cable, Connect/disconnect the cable

Getting Started

Install the Interface Cable

Connect the reader cable by inserting the cable into the handle as shown in Figure 1. To remove it, insert a paper clip into the release aperture, then unplug the cable.

Figure 1. Connect/disconnect the cable

RS-232 Serial Connection

Turn off power to the terminal/PC and connect the reader to the terminal/PC serial port via the RS-232 cable as shown in Figure 2. If the terminal will not support POT (Power Off the Terminal) to supply reader power, use the approved power supply (AC Adapter). Plug the AC Adapter barrel connector into the socket on the RS-232 cable connector and the AC Adapter plug into a standard power outlet.

Figure 2. RS-232 Connection

12 Gryphon™ I GD4100