Panasonic WV-NW474SE, WV-NW470S Network Setup Network Setup, Http Port Number

Page 29

■Network Setup (NETWORK SETUP)

Set up network parameters when connecting the 10/100BASE jack with a network.

Notes:

•Access the setup menu from the PC to use the DHCP or DNS server, because these settings are not included in this window.

•Ask your system administrator or ISP (Internet Service Provider) about available IP address, subnet mask, and gateway, prior to setup.

•The assigned address should be a global type when connecting via the Internet. Ask your ISP whether it is.

** NETWORK SET UP **

IP		ADDRESS	192.168.	0.	10

NETMASK			255.255.255.		0
GATEWAY			192.168.	0.	1
HTTP PORT NO.					80
DHCP			OFF

RET END

1.Move the cursor to NETWORK SETUP in the SETUP menu window and press [SET]. The NETWORK SETUP menu opens.

The factory default settings are as follows. IP ADDRESS: 192.168.0.10 NETMASK: 255.255.255.0 GATEWAY: 192.168.0.1

HTTP Port Number: 80

DHCP: OFF

2.Move the cursor to the line you wish to edit, and press [SET].

Parameters become editable.

3.Select a digit using [Left] or [Right].

4.Select a number in the digit using [Up] or [Down].

5.Repeat steps 2, 3 and 4 above appropriately until all parameters are set.

6.Move the cursor to END and press [SET] to close the setup menu and store new settings, or select RET to go back to the SETUP menu.

Note: The port number assigned to the camera is exclusive, and any other usage is not allowed.

-29-

Image 29

Contents WV-NW474SE Risk of Electric Shock Do not Open Contents Preface FeaturesSystem Requirements TrademarksDocument Convention Handle the camera with care PrecautionsNever face the camera towards the sun Do not aim the camera at the same object for a long timeMajor Operating Controls & Their Functions @3Control connector 8DIP switch@4Power cable @2Video output connectorInstallation Plans & Preparations InstallationInstallation space ProcurementOptional Heater Unit Mounting the CameraWire colours & functions AC Type Power ConnectionCable length and wire gauge 24 V AC Type ConnectionsControl Connector Image AdjustmentVideo Output Connection Network Port ConnectionWaterproof Process Direct Connection to PC Type Network Connection TypesConnection to Intranet Type Connection to Internet TypePreparations for Network Connections Network Setup of Your PCUsing Panasonic IP Setup Software Network Setup of the CameraDdns Dhcp DNSPage Buttons Used for Setup Prior to Camera SetupCamera Setup Menus ALL Reset button¡From the Camera Setup Menu Tree Setup Selection Setting ProceduresCamera Setup Menu CAM Camera Identification Camera ID SettingCommand Usage Light Control Setting ALCTo edit the Camera ID To replace a specific character in the Camera IDElectronic Sensitivity Enhancement Sens UP Gain Control Setting AGC on DNR-L, DNR-H/OFFShutter Speed Setting Shutter ATW1 Auto-Tracing White Balance Synchronization Setting SyncWhite Balance Setting White BAL Automatic White Balance Control Mode AWC Motion Detector Setting Motion DETManual Fine Adjustment for AWC ATW Push SWSpecial Menu Special Menu/DIP SW Selection10-6. BW To reset to the factory settings Camera ResetHttp Port Number Network Setup Network SetupInitializing Initializing the Setup MenuInitializing the Camera Menu Initializing Html FilesTroubleshooting TCP/IP, HTTP, FTP, SMTP, DNS, DDNS, DHCP, ARP, BOOTP, NTP SpecificationsPrevention of Blooming and Smear Network SectionOptional Accessories Standard AccessoriesGeneral WV-NW474SEOptional Heater Unit WV-CW3HE Appendix在日本印刷