Panasonic WV-NW474SE, WV-NW470S operating instructions Troubleshooting

Page 31

TROUBLESHOOTING

Symptom

What to do

Reference page

No picture is displayed.

• Is the 24 V AC or 220 V - 240 V AC cable firmly connected?

11

 

• Is the video cable or network cable connected properly?

 

 

 

Cannot access the camera from the

• Are the network cables connected properly?

 

browser.

• Is the status indicator lamp of the network connection termi-

 

 

nal on?

 

 

If not, a network connection has not been established or the

 

 

other devices are not in operation.

 

 

• Is a valid IP address set for the camera?

11, 15-18

 

• Are you connecting to a wrong IP address?

 

 

 

Open the command prompt on your PC and enter:

 

 

>ping (enter here the IP address set for the camera).

 

 

If the camera replies, the connection is correct.

 

 

If not, set the correct IP address for your PC and/or to the

 

 

camera.

 

 

 

 

HTML documents are not displayed.

• HTML files in the camera might be broken. Initializing is

30

 

required.

 

 

 

 

-31-

Page 30 Page 32
Image 31
Page 30 Page 32
Contents WV-NW474SE Risk of Electric Shock Do not Open Contents Trademarks FeaturesPreface System RequirementsDocument Convention Do not aim the camera at the same object for a long time PrecautionsHandle the camera with care Never face the camera towards the sunMajor Operating Controls & Their Functions @2Video output connector 8DIP switch@3Control connector @4Power cableProcurement InstallationInstallation Plans & Preparations Installation spaceOptional Heater Unit Mounting the CameraConnections Power ConnectionWire colours & functions AC Type Cable length and wire gauge 24 V AC TypeNetwork Port Connection Image AdjustmentControl Connector Video Output ConnectionWaterproof Process Connection to Internet Type Network Connection TypesDirect Connection to PC Type Connection to Intranet TypePreparations for Network Connections Network Setup of Your PCUsing Panasonic IP Setup Software Network Setup of the CameraDdns Dhcp DNSPage ALL Reset button Prior to Camera SetupButtons Used for Setup Camera Setup Menus¡From the Camera Setup Menu Tree Camera Identification Camera ID Setting Setting ProceduresSetup Selection Camera Setup Menu CAMTo replace a specific character in the Camera ID Light Control Setting ALCCommand Usage To edit the Camera IDShutter Speed Setting Shutter Gain Control Setting AGC on DNR-L, DNR-H/OFFElectronic Sensitivity Enhancement Sens UP White Balance Setting White BAL Synchronization Setting SyncATW1 Auto-Tracing White Balance Push SW Motion Detector Setting Motion DETAutomatic White Balance Control Mode AWC Manual Fine Adjustment for AWC ATWSpecial Menu Special Menu/DIP SW Selection10-6. BW To reset to the factory settings Camera ResetHttp Port Number Network Setup Network SetupInitializing Html Files Initializing the Setup MenuInitializing Initializing the Camera MenuTroubleshooting Network Section SpecificationsTCP/IP, HTTP, FTP, SMTP, DNS, DDNS, DHCP, ARP, BOOTP, NTP Prevention of Blooming and SmearWV-NW474SE Standard AccessoriesOptional Accessories GeneralOptional Heater Unit WV-CW3HE Appendix在日本印刷
Top Page Image Contents